Chevy Camaro
Acura Integra
Nissan Pathfinder
Ford F-150

How do you change the oil pan gasket on a 1990 Acura Integra GS 4dr?

343536

Top Answer
User Avatar
Wiki User
2009-02-09 04:33:26
2009-02-09 04:33:26

To change the oil pan gasket, jack up the car and make sure it is secure before you get underneath, look to where the oilpan is (look for the drain bolt) all around the upper of the oilpan there are bolts (approx 8) empty the oil thru the plug, then remove these bolts, the pan will come off and there is the gasket on the outer edge of the pan. you must also remove a section of the exhaust to drop the oil pan and there is also a crossmember that runs front to back on the car you must remove

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace an alternator on a 1990 integra

User Avatar

There is a gasket between the master cylinder and the booster of a 1990 Acura Integra. It is shaped like the side of the master cylinder with two bolt holes.

User Avatar

wiper intermittent relay 1990 acura integra

User Avatar

The manual that came with my 1990 Acura Integra GS indicates to use Dexron II. If you change the fluid only it's 3.2 qts. I hope this answers your question.

User Avatar

Yes that year integra is equiped with ABS

User Avatar

Check your negative cable to the battery.

User Avatar

Yes it should. Im 99% sure it will. you might want to double check the part number to see for sure. i have a 1990 Acura integra and i have used many parts from integras from 1990- 1993.

User Avatar

Try behind the grill but in front of the rad

User Avatar

i am pretty sure there are no daytime running lamps on a 90' integra...

User Avatar

No there is not a Chip in 90 Integra. I have a 91 intergra and made copies at Home Depot

User Avatar

nope don't believe so, 98 runs on hydro tranny and 90 runs with cable tranny..

User Avatar

124 mph electronically governed

User Avatar

It controls practically everything. It is the "Brains"

User Avatar

If timing is bad on a 1990 Acura Integra they car will either run incredibly rough out not at all. To fix the timing be sure to correctly align the distributor to the right factory specified degree.

User Avatar

well i had that problem with my integra, all i did was change the ecu to a single cam si ecu (PM6) or another ls ecu (Pr4) that should fix the problem

User Avatar

On my 1990 integra, there are like 5-8 bolts underneath and 1 or 2 on the inside of each wheelwell

User Avatar

there really isnt. a 90-93 integra has the b18a1 engine and the 94-95 integras have the b18b1 engine. the only difference is some small wiring differences and sensors that were added to the 94-95 integras


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.