remove the 2 bolts on the outside of the lense then pull the assembly out.
Geo Prizm door handles are the same 1993-1997
This might be helpfful. How do you Change a fan belt on 94 prizm?
This was for a 1994 but try searching here. How do you Change a fan belt on 94 prizm?
From the inside. Remove the door panel to get to the handle. To remove the inside handle, there should be a cover over the screw that holds the handle. It is the entire curved piece where your finger goes when you pull the handle. One screw under the cover. The entire handle slides forward about 1/4 inch and then comes out enough to remove the rod that goes to the lock. Once you have the panel off the outside handle is held on with 2 bolts. 10 mm socket. A swivel helps to get them out, at least for me. It's not the worst job.
how much cost to change a clutch for a geo prizm 1995
behind the drivers side rear tire on the frame
You'll have to remove the door panel in order to access the bolts holding it on. Not real difficult, just kind of a pain in the rear to do.
in the tank. There is an access hole under the rear seat on drivers side
Written in the owners manual and on the drivers door post.
Begin by removing the interior door panel. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install your new interior door handle.
Look here: How do you change the starter on a 1996 Toyota Corolla?Prizm and Corolla engines are the same.
Under dash, drivers side on left. Small black relay.
Front or Rear? Both
Every 5.000 miles
You may find some help by searching for this question.How do i replace the water pump on a 1993 Geo Prizm 1.8L?
From inside the trunk.
If it's automatic, it's on the drivers side of the engine towards the battery. It should be easy to spot. Generally on a Geo Prizm it is located on left side of the coolant overflow container. Top of dipstick should be red.
3.9 Quarts in a 1996 SD with a filter change. 3.7 if you don't change filter.
Replace every 60,000 miles.
to change the wheel and tire on a car just loosen the bolts on the wheel jack it up and replace it
See the answer for the 90 model. Should be the same
May have to change oil.
Its a non interferance engine and they rarely need to be changed
1.6 liter holds three quarts with a filter change.