answersLogoWhite

0


Best Answer
Copy

(i) Use a "star" screwdriver to unscrew the two(2) black screws on the outside.

On the inside if there is a canvas remove this by gently unscrewing the two(2) black plastic screws

(ii) Use a No. 8 spanner to remove the nut on the inside.

(iii) Pull gently the whole casing containing all the rear lights(brake/turn signal/reverse/blinkers)

(iv) Determine which bulb needs replacement by switching your lights on and have someone step on the brakes for you.( with the ignition turned on)

(v) The part number( for brake light) is 1157 and is available at the nearest Autozone

(v)Remember not to lose the screws Replace everything as it was

Happy Driving.I just change mine today 1/3/05.

I did this today 7/14/10. The only thing that was confusing for me was removing the whole casing. You have to jiggle it a little to manuever it off because the outside part is hooked on.

User Avatar

Wiki User

โˆ™ 2010-07-14 16:46:50
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change the rear brake and tail lights on a 97 Toyota Corolla?
Write your answer...
Submit

Related Questions

How do you change rear brake pads on a 2001 Toyota Corolla?

How do I change the Front Brakes on a 2001 Toyota Corolla?


How do you change rear brake pads on 2002 Toyota Corolla?

How do you replace the front break pads on a Toyota corolla .


Why does my 1996 Toyota Corolla start but will not go into gear. And I do not have brake lights eighter?

A brake light switch may be bad if a 1996 Toyota Corolla will not go into gear and the brake lights don't work. Another issue could be in the shift lock solenoid.


What makes brakes lights stay on 93 Toyota Corolla?

A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.


What causes brake lights of 1994 Toyota Corolla to remain on?

Defective or mis-adjusted brake light switch


Why don't brake lights turn off on an 89 Toyota Corolla?

Check the brake light switch located under the 1989 Toyota Corolla. If the switch is stuck the parking light will continue to stay on.


Where is the brake switch on a 1999 Toyota Corolla?

The brake switch on a 1999 Corolla should be on the top of the brake pedal arm. If the switch goes bad, then the brake lights might stay on, or not come on at all.


Where in the trunk is the controller for the brake lights located in a 1991 Toyota Corolla?

If by 'controller' you mean the switch that makes the brake lights come on, it is not in the trunk. It is located underneath the dashboard, next to the brake pedal.


Which fuse corresponds to the brake lights on the 95 Toyota Corolla DX Sedan?

The number 15 fuse will be the brake light fuse in your 1995 Toyota Corolla. The number 15 fuse can be found in the second column, fifth from the top.


Where is the brake fluid filler located on a 2004 Toyota Corolla?

Where is the brake fluid filler located on a 2004 Toyota Corolla?


What does it mean when the brake and battery lights come on in 1988 Toyota corolla?

Do you mean What does it mean when the brake and battery lights come on in when it is already started? Check your alternator may be its not working well it cause the battery sign comes out.


What is the brake rotor specs for 93 Toyota corolla?

The brake rotor specs for 93 Toyota corolla the outside diameter 255 mm and inside diameter is 142.2 mm.


Where is the brake switch located on the 1996 Toyota Corolla?

Is located on top of the brake pedal


How much is a brake job at Midas?

2014 TOYOTA COROLLA


There are two lights on the trunk lid of a 91 Toyota Corolla on either side of the license plate lights these are not the brake lights are they supposed to be working or are they for show?

they are for night illumination of your license plate. Illegal if they are not working at night.


Why wontBrake lights wont turn off 97 Toyota corolla?

Your brake lights are actuated by a switch that is connected to the brake pedal or to the hydraulics. It's sticking in the closed position. Just follow the pedal down until you see the wire.


How long does it normally take to replace brake lines on a 1995 Toyota Corolla?

It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.


Why a 1995 Toyota corolla brake pedal is soft when the engine is running?

Brake system has air in it.


What kind of brake fluid is used in a 1995 Toyota Corolla?

When refilling brake fluid it is important to use the correct type of fluid for the car. For a 1995 Toyota Corolla the correct fluid is brake fluid dot 3 or brake fluid dot 4.


How do you regulate clutch in Toyota Corolla?

Disconnect you brake system and die


How do you change brake pads on a 2004 Toyota corolla?

Chilton's manuals can often be accessed online through your local library's website.


Why won't the brake and parking lights turn off in a 1992 Toyota Corolla?

Brake and parking lights? Are you sure, the two aren't interconnected. Maybe it's just the brake light. If so, sounds like a bad brake light switch. If you step on the brakes and the brake and parking (sometimes called running lights) lights come on it sounds like you have a real problem. Suggest you have it checked right away.


How do you change brake LIGHT bulb on 1984 Toyota corolla?

In 1984 Corolla sedan and coupe the brake lights are mounted in the trunk lid. Just grip the socket and turn counter clockwise 1/4 turn and the bulb and socket will come out, grasp bulb and another 1/4 turn bulb will come out. Sylvania Part № 7443LL 2 filament bulb (same bulb is tail lights)


How do you reset the ABS and brake lights on a 2000 Toyota MR2?

To reset the ABS and brake lights on a 2002 Toyota MR2, trying disconnecting the battery for 10 minutes. A Toyota dealer can also reset the lights.


How much does it cost to change brake pads on a 2000 Toyota corolla?

Most places like brake masters, Midas etc. will do one axel, front or rear for about $100.