0
How do you change the spool on a craftsman bushwacker weed eater?
Wiki User
∙ 15y ago
I can't seem to get the spool off.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Which brand of trimmer has the fewest spool tangles?
The Weed Eater brand of trimmers have very few spool tangles
Cant get the spool out of a craftsman line trimmer?
1. Rotate spool to line up arrows on spool and surrounding casing. 2. Find notch and pry with wide flat-end screwdriver. 3. Spool will pop out.
Change the spool of line on a weed eater SG11 Can't figure out how to get the original one off?
Locate the round tap button. Pull it straight out, firmly. This opens the chamber for new line or spool. I figured this out five minutes ago.
How do you change the spool on a weed eater rt112c?
You can find the User's Manual at the following web address for Poulan.Com http://72.3.225.179/manuals/545186760en_r1.pdf Hope this helps.
Do a electric weed eater have littke bb's in it?
No, electric weedeaters have a motor and a cord spool.
How do you wind new weed eater string on an old spool?
pull straight out to remove the spool, wind in the direction of the arrow - to replace, feed the string through the hole and pull on it, keeping slight tension on the spool as you push it back into the head
What if string isn't coming out of weed eater?
It's tangled on the spool. You need to open & rewind around it.
Looking for Craftsman 24 Volt Weed Wacker part number 71.74805?
Need full spool replacement
How do you get the spool off a weed eater twist n edger TE 15?
The spool can be taken off a Weed Eater Twist N Edger TE 15 by pressing inward and turning it counter clockwise. This allows more cutting line to be added or jams to be cleared.
Craftsman model 257.796050 need to know how torestring spool?
Read the owners manual in the link below. It will explain how to restring the trimmer.
What is the procedure for re stinging the spool on a Weed Eater Model RTE113C?
Line the mark up with the arrow and pull real hard.
How do you re string dual no bump weed eater?
it actlly all depends on which head you have...but regardless always roll spool putting the line on it, don't roll the line, but the spool, keeps the line able to come off when bumping, if you wind the line around the spool it will normally melt and prevent it from feeding.
