answersLogoWhite

0


Best Answer

hey this is pretty easy to do first block the wheels, jack the truck up then drop the drive shaft out remove c-clips from the ujoints then take a socket or piece of pipe that fits in the hole and hammer the old one out after they are out clean up the ujoint holders and install the new ones carefull of the pin bearing inside them put driveshaft back in ready to go hope this helps a little

User Avatar

Wiki User

โˆ™ 2006-09-16 17:11:34
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the u joints on a 1988 ford ranger?
Write your answer...
Submit
Related questions

How do you change ball joints on 1991 ford ranger?

You need to remove the spindle and press out the ball joints & press in new ones


Diagram of a fuse box for a 1988 Ford Ranger?

diagram of fusebox on 1988 ford ranger


Water pump for a 1988 Ford Ranger at?

i need help with the temp.gage in a 1988 ford ranger


How do you change upper and lower ball joints on a 1992 ford ranger super cab 2wd?

how do i change a lower ball joint on a 1992 ranger 2wd


How do you change the ball joints in a Ford Ranger?

1998 2wd What year? 2WD or 4WD? 2WD 1996


What type of oil does a 1988 ford ranger take?

10W30 is the type of oil that a 1988 Ford Ranger takes. The Ford Ranger was first produced in 1983 and discontinued in 2012.


How do you change upper and lower ball joints on a ford ranger?

Depends on whether you have coil springs or torsion bars.


How do you replace a broken throttle cable on a 1988 Ford Ranger?

how do i replace a throttle cable on a 1988 ford ranger pickup


How do you replace a u- joint on a Ford Ranger?

how to replace u-joints on 1995 ford ranger 2wd


How do you change a 1993 Ford Ranger clutch?

how to i change a clutch in a 1993 ford ranger


What kind of brakes are on front of 1988 Ford Ranger pickup truck?

fordparts.com shows disc brakes on the front of a 1988 Ford Ranger


How do you change ball joints on a Ford Ranger?

It depends on the year, and whether it's 2WD or 4WD. I suggest entering your question again with the year. People have posted answers for specific year models. All Ford Rangers from 1993 to 1997 have "I-beam" front suspensions as opposed to the upper and lower control arms that most vehicles have. There is a detailed answer for replacing the upper and lower ball joints for '93 through '97 Ford Ranger ball joints at the question: "How do you change ball joints on 199X Ford Rangers?"


Why cant i get fuel to engine on a 1988 ford ranger?

Either change fuel filter or fuel pump...


Does a 1988 Ford Ranger have o2 sensors?

I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )


How do you change dash lights on a 95 Ford Ranger?

How to change dash lights on a 95 Ford Ranger?


How do you change the lens cover on a 94 Ford Ranger?

how do you change tail light cover on a 1994 ford ranger


How much horse power does a Ford Ranger XL 1988 2.9?

I believe the 2.9 liter V6 engine in a 1988 Ford Ranger is rated at : ( 140 horsepower )


How do you set the timing belt on a 1984 Ford Ranger 20L?

How do you set the timing on an 1988 ford ranger 4 cylinder


How do you set the timing on a 1991 Ford Ranger after the timing belt breaks?

where to set timing for a 1988 ford ranger 2.2l


Change a tie rod on a 1992 Ford Ranger xlt?

how to change a tie rod on a 1992 ford ranger xlt


How do i repair the slave cylinder on my 1988 Ford Ranger?

The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.


How do you change a timing belt on 1991 Ford Ranger?

how do u change a timing belt on a 94 ford ranger need help


V6 2.9L Ford Ranger 1988?

Yes , there was a 2.9 litre V6 engine available in a 1988 Ford Ranger , as well as the 2.0 and 2.3 litre four cylinder engines


How do you replace a motor mount on 2002 Ford Ranger?

how do you change motor mount on 2002 ford ranger


How do you change the fuel filter on a 2003 Ford Ranger XLT and where is it located?

how do you change a fuel filter and were is it located on a 2000 xlt ford ranger