Thermostat Removal & Installation 1. Disconnect the negative battery cable. 2. Drain and recycle the engine coolant. 3. Remove the Power Steering reservoir support bracket. 4. Remove the upper radiator hose at the thermostat housing. 5. Remove 2 thermostat housing retaining bolts and remove the housing. 6. Remove the thermostat and O-ring from the lower intake manifold. Discard the O-ring. To Install: 7. Clean the O-ring sealing surfaces. 8. Install a new O-ring, on the thermostat and position the thermostat in the lower intake manifold. 9. Place the thermostat housing on the lower intake manifold and install 2 retaining bolts. Tighten the bolts to 15-22 ft. lbs. (20-30 Nm). 10. Install the power steering reservoir support bracket. 11. Fill the engine cooling system. 12. Connect the negative battery cable. 13. Start the engine and allow it to reach normal operating temperature while checking for coolant leaks. 14. Road test the vehicle and check for proper engine operation. 15. Check the coolant level and add if necessary.
how to change brake lines on a 1996 ford econoline e-150
Change brake pads on a 1983 ford f 150 van
need to see what fuses operate what in a 2004 ford 150 econoline.
where is the computer on 1988 ford econoline 300 6cyl
where
Econoline ( originally )
R134a
yes
Use a key.
No, fuel injection.
A little more information please Model year of Ford E-150 , engine size
I have a 1991 Ford Econoline E-150, 5.0 liter, auto trans w/ over drive, plus handicap eqp. I get 12.5 mpg