[sudo] acpi -b
how to know the battery lifes for casio fx-570ms
You simply look at the top of the iPod screen, and there should be a battery icon there.
A lot would depend on how long it takes to get hot. Try checking the engine coolant level ,next, check the oil level. Then check the battery.
No, some have top terminal, and some have side terminals. Batteries come in different CCA ratings (Cold Cranking Amps), basically it tells you the power-out of the battery and correlates with size of the battery. These days, all batteries are of the sealed type which means you don't have to add or check electrolyte level.
Install a New Car BatteryInstalling a battery for your car is a very easy task that can be done with a few simple tools. Anybody with a little mechanical knowledge can perform the task.Battery Placement and SecurityBegin by placing your battery carefully onto the battery platform. Make sure the platform is clean of debris so that the battery sits level. Then take the battery bracket, which is used to hold the battery in place, and tighten it down using a socket wrench. Now that the battery is securely held in place, be sure to check that you have everything else in place before connecting the battery.Connecting The BatteryBefore connecting the battery, it's a good idea to place a protective rubber casing over the connection so that it sits between the battery cable and the battery casing. This will prevent any corrosion of the casing to occur. Start with the positive battery cable. Place it over the terminal connection until it is all the way down and the terminal is sticking out above the terminal. Tighten the cable securely to the terminal with a wrench. Repeat the same procedure with the negative battery cable and you will be good to go.
Red means that the battery charge level is low or that the alternator is not charging battery properly. Check alternator, voltage regulator, connectors.
When any conducting material is connected to provide a continuous path between the two terminals of a battery, electric current flows through it. On the microscopic level, electric current is really the flow of electrons, from the battery's negative terminal, through the conducting path, to its positive terminal.
i can't detect key for satart
Remove the battery, and disconnect the negative terminal first. If you have a battery charger you connect the terminals to the appropriate wires, the red wire is for the plus terminal and the black or blue on for the negative terminal. Adjust the voltage to 12 volts on the charger. It can take up to several hours to charge the battery or even overnight. Remove the plugs from the battery cells and fill up to the correct level with battery fluid or distilled water. Don't use tap water. When the battery is fully charged as shown by the meter on the charger, you can re-insert the plugs for the cells and then reinstall it in the bike. In case you don't have a battery charger, you can ask any battery service shop to charge it for you. They will do this for a small amount.
Overcharging. Check your electrical system to see if the alternator is overcharging the battery. It can also be the battery is defective and needs replacing.
It's underneath the battery. It's a bit frustrating to have to take out the battery just to check your fluid level
No, just view terminal til it turns red. Then either get the next one on the level or quit.