Best Answer

first have an assistant turn the ignition switch to the on position and listen for the whirring sound from fump pump, indicating pump is operating. If fuel pressure is in question you can install a tee fitting between fuel filter and fuel line and purchase a fuel pressure gauge to connect to the tee fitting. fuel pressure should be at 43psi with key on engine off, and 34 to 36psi with engine idling.

User Avatar

Wiki User

โˆ™ 2006-08-15 16:26:45
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you check the fuel delivery to the injectors from the fuel pump on 92 maxima?
Write your answer...
Related questions

How many fuel injectors does a Nissan maxima 3.5 have?

has 6 injectors

How many fuel injectors does a 3.0 maxima have?


2000 maxima fuel to lean check engine code?

Check fuel delivery. fuel pump may be operating below threshold or fuel filter may be clogged.

How many fuel injectors does a 99 nissan maxima have?


How many fuel injectors are in a 1997 Nissan Maxima?

There are 6 fuel injectors, one per cylinder. They are located on the top of the engine.

1992 Nissan Maxima runs rough at idle?

Fuel injectors

What should you do if the fuel injectors are flooding on your 1987 Nissan Maxima and there are problems with starting?

The original fuel injectors on that model were recalled - did you ever have them replaced?

What does a fuel shutoff switch do?

Stops fuel delivery to injectors or carb.

Fuel at rail but not injectors?

Check fuel pressure to be sure it's in spec. If it is, then you must check the injectors for pulses.

How do you replace fuel injectors for 1992 Nissan maxima SE?

How do you replace the fuel injectors on a 2001 Saturn SC1?

Remove the fuel rail with injectors then separate the injectors. Check related link below:

Can you put in 1990 fuel injectors in a 1993 maxima same engine?

yes if it's the same motor

Is there anything you can put in your Nissan maxima to unclogg the converter?

I heard that racing fuel will clean out your injectors and converter.

What would cause a misfire on a 1992 Nissan Maxima with 85000 miles?

In order to have complete combustion you need only a few things.-Spark-Fuel-Air-Compression-Correct TimingAny of these things could cause a misfire.A common problem with the 1992 Nissan Maxima is the fuel injectors. I would check the resistance on them and check the wiring harness.

My 93 Nissan Maxima does not have a lot of power and drinks lots of gas?

You either have bad fuel injectors or your fuel pressure regulator has gone bad

1983 Volvo 240 DL Why no fuel at injectors after replacing both fuel pumps and filters?

fuel pressure regulator, or clog due to poor fuel, and check injectors

My 2001 olsdmobile alero haves a gas leak close to the injectors?

Yous should check the 'O ring' or check the fuel injectors 'O ring' on the fuel rail.

No fuel to injectors?

first check to see if fuel filter is clogged.if you have an electric fuel pump, check the fuel pump fuse. next check the fuel lift pump. then check the injector pump

How do you change the fuel injectors on a 4.0 Jeep Cherokee?

check your answer

How can you check if there is power going to the fuel injectors on my gmc sirrea with a 305?

use a noid light set to determine if pulse is going to the fuel injectors.

Car give a clunk sound and wont start but everthing turns over?

check the fuses to the fuel pump and the fuses to the fuel injectors if you have injectors.

Would something electrical effect fuel delivery on a 2000 Toyota Echo?

It's possible, fuel injectors are computer controlled, and the fuel pump is electric.

Why Nissan 300zx will not start unless i use starter fluid?

no fuel to the injectors check fuel filter or replace check fuel pump see if it's working check relay

Where is the fuel filter on a 2003 Nissan Maxima?

Check out this website for details on how to find and replace the fuel filter on a 2003 Nissan Maxima.Visit the Related Link below for more on this.

All fuel injectors stuck open on your 1991 Nissan 300zx?

When all fuel injectors are stuck open, this generally means that the injectors are not getting the right voltage. You will need to not only check the voltage, but make sure the injectors are receiving the right signal.