Wiki User
∙ 12y agoI hate to answer a question with a question but why do you need to check it as it is a sealed unit and as per Jaguar does not need to be checked so they say.......
Having said that there is a Allen head screw on the right side about 3inches above drain plug. Take it off and see if fluid comes out if not add until it runs out and put Allen screw back in. No there is not a dip stick. To add fluid there is a rubber plug or Allen screw on top of tranny behind battery box. You will need a long funnel.
Casimir Keebler
Check plugWhat type do you have? On the X-type- fill plug is a rubber plug on top of the tranny. The check is-remove the Allen plug about 6-8 inches from the fill plug, add till fluid flows out. Engine must be on. I have a new style s type. Any idea how to check this?Where is the Allen plug located from the fill plug? Underneath trans, side or top? We have a 2002 all wheel drive automatic transmission Xtype.
12mm x 1.50
how do you remove and replace rear bumper on an xtype jag
rough running, water or emulsion in oil, oil or emulsion in water (floating on water in top of radiator), steam from exhaust, compression test to check.
Ford Nope JLR Jaguar Landrover .... who is owned now by Tata Motors in 2002 Ford owned the company, but the vehicles have always been made by Jaguar Landrover at the Halewood plant in the UK never at a Ford plant.
my jaguar xtype is beeping, and now my brake lights don't work when my headlights are on. Do I need to replace a fuse or reset the rear sensor? Thanks Jasmin-
It is rich or lean bank 1 or 2 i am not sure which one it is but i know it is rich or lean code they have the same codes as ford.
THe Jaguar XType has the best safety rating. It got 4 out of 5 stars on the crash rating. It has side airbag curtains and active head restraints and airbag occupancy sensors.
fuse for power window 2002 xtype
its in the glove box you have to open a little hatch first and a torch will help ,its a bit dark You can find pictures and details here:- http://www.brendastuart.co.uk/xtype/blue_spring/ you may need to cut and paste the address into your browser i have a 2002 x-type and mine is under the steering wheel to the left side
malcom xType your answer here...
Attach a brake bleeder tube to the bleeder valve, loosen but dont remove caliper mounting bolts. with the old inboard disc pad still installed and the outer disc pad removed use a large "C" clamp to apply pressure while bleeding the brake fluid. This allows the cylinder to retract into the caliper without allowing air to enter the system. Also a reminder, As you know the caliper assembly is a little heavy and you'll want to support its weight so it is not "hanging" by its expensive hydralic brake line (hose). a metal coat hanger tied to the coil spring and run through the caliper mounting hole works well.