Yes the 1994 Mazda Protege is a OBD 1 port
where is the modulator vavle on my 1994 Mazda protege dx?
The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
there is no dip stick for a manual transmission .there is a bolt on the side of the trans you have to pull then stick your finger in ..if you can touch it its ok
is under the transmission stick console, heres a web page for mre info. http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English
No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.
On the top of the transmission, with a harness headed to it, should be about 3 bolts to take off, then valve comes off... shift solenoids are in there
Check battery Check battery cables for corrosion or looseness Check fusable link
The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.
try going on ebay!
that is the cooling fan relay.
the alternator is located under the inlet manifold
14.5 gallons AFAIK.
Like any other wheel?
6.5 inches. No screw patters match the protege, you'll have to drill alittle bit.
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.
Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.
Behind the engine, under neath the intake manifold.
Email me for the Fuse diagram email@example.com
Fuel filter is located in left rear (firewall) corner of engine compartment. check near the brake booster/master cylinder.
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
When you remove the caliper, the pads can be pressed out by hand.