Could be an EGR port clogged with carbon. Remove and clean EGR and EGR ports.
pull it off and clean with some carb cleaner
You can clean the E GR valve by removing the valve and soaking it in a cleaning solvent. You can clean the ports with the same solvent. Wipe everything dry after cleaning.
You more than likely have a clogged egr port. Remove the EGR valve and clean the ports going to the engine with carb cleaner.
They usally don't need cleaning most require replacement or the eve ports need cleaning
the ports are the awkwardplate looking thing on the top those are the ports. the egr valve itself is located next to the distributor. it has a grey plug and a vaccum hose attached to it and it is bolted on to the manifold with two 12mm nuts. it is possible to take off withought removing intake manifold. clean with choke cleaner and a brush, suggestions also run seafoam through throttle body and try to use every 6 months i was told to help clean ports
The EGR valve is normally connected to the exhaust manifold. The EGR valve works by routing a small amount of the exhaust gases back into the combustion chamber. This helps reduce emissions of noxious gases to the atmosphere. You could try removing the EGR and then try to clean it inside with a rubber-friendly cleaner that is strong enough to break down carbon build up. Ask a car parts and accessories store for advice about the right type of stuff to use. Just an added note. I had a 1993 Honda Accord that was running very rough from 800 to 2500 RPM's. Almost like it was misfiring. The technician said the EGR valve was very dirty with evidence of carbon build-up. The problem continued after the EGR was cleaned and I had to clean out the 6 EGR ports. They had port access caps that had to be drilled out (on a Honda accord). The symptoms and repair were from the manufacturer's service bulletin. They are coat hanger size ports and were very clogged and the car runs great since cleaning the ports. I believe most cars have EGR ports tied to the EGR system. They tie the exhaust to intake airflow manifold for recirculation.
The 2001 Honda Odyssey EGR valve is located on the outside of the air cleaner housing. You will find the valve, on the back of the housing.
P0401 indicates an insufficient flow of gases through the EGR system. While Honda EGR valves occassionally fail, your first step should be to check if the EGR is operating when vacuum is applied. If so, remove it and clean the orifice with brake cleaner. While you have it off, clean the intake porting with carb cleaner and a stiff wire brush. Carbon build up in either the EGR or the intake will set this code.
how do you clean a egr valve on a vauxhall zafira 1.6
Sorry, I'm looking for the same answer. I just brought my 2001 Ford Expedition 4.6L V8 to the shop because the Check Engine Soon Lights is on. I paid $73 dollars. They told me my EGR Valve need replacing and the EGR ports need cleaning. Estimated price $600.00. So if anyone can tell us this I would and my wallet would be very greatful..
Operate the EGR valve manually if possible. If the engine doesn't stumble and die, the ports are likely plugged. Remove the valve and clean all of the ports. Check all vacuum lines, hoses, etc. for any damage.