Mark driveshaft, yoke, and splines so that drifshaft is replaced at same location to maintain factory balance
Both yokes (rear end and transmission) are bolted in so you must removal four blots around each yoke 17mm bolt and 15mm nut in order to removal drive shaft.
the center drive shaft support is bolted in with four 12mm bolts.
after all hardware has been removed the drive shaft slides out. easier to pull out from the front of the drive shaft loop.
no spark
by looking at georga
about 3117 lbs
114 for non-turbo about 160 for turbo
in the center console, under the Radio
Broken valve spring
Probably - remove distributor cap and look
in the fuel tank? just a wild guess.
Usually in a removable housing at the engine end of the upper radiator hose
under an behind ash tray remove ash tray an all will be answered
87 octane regular unleaded.
Take it to the junk yard starter is almost impossible to remove . Good Luck