answersLogoWhite

0

How do you disable IDE bus master?

Updated: 11/10/2022
User Avatar

Wiki User

12y ago

Best Answer

Reboot your computer, and at the startup screen open boot menu, by clicking either DELETE, f2 or f11, depends on your pc. Go into CMOS settings, and choose your primary master. It should be in there, might be abbreviated as:"DMA"

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you disable IDE bus master?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the four possible configurations for four IDE devices in a system?

Primary IDE Channel , Master Device Primary IDE Channel , Slave Device Secondary IDE Channel , Master Device Secondary IDE Channel , Slave Device


Should ide be master or slave with sata master?

SATA and IDE are operated on different buses, with different controllers. A SATA drive is not considered a "master" or a "slave"; it has a channel all to itself. If the IDE drive is by itself on the controller, it should be set as Master.


If a single hard disk is attached on a primary IDE channel what should the jumper be set to?

master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.


What should the primary jumper be set to On a primary IDE channel if a single hard disk is attached?

master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.


How many drives must be set to master in a PC with IDE drives on the same cable?

Only one master is connected to single IDE cable


What must an IDE hard drive have in order for an AGP slot?

The IDE drive has no direct correlation to the AGP bus.


An IDE cable has both a master and a slave connection?

yes


What is a primary master IDE HDD known as in Linux?

ide0


What is ATA bus comntrol?

The IDE/ATA bus controller manages the flow of information between the hard drive and the rest of the computer. At this point in time, The IDE/ATA bus controller is typically built into the motherboard so hard drives can be connected directly to the motherboard.


What determines master or slave on ide ribbon cable?

The Jumper Settings


When installing an IDE hard drive's configuration a master or slave is handled?

the hard drive should be set to master...


NJ transit bus pass service for the disable?

I will like to get a NJ Transit Bus Pass.