Remove the fuse or the relay.
Locks of Love was started in 1997.
Check for proper fuel pressure in the 1997 Talon. The engine appears to be starving for fuel and only has enough pressure to start.
power door locks don't work on my 1997 Honda crv
If you have the codes read and repair what is wrong with the vehicle the light will go out on its own, or can be reset by the tech.
1997 chev Malibu doesn't start but then if relay is wiggled by engine under hood car starts can this be fixed
The factory alarm is part of the engine and body computers. It can not be disabled. It is reset by unlocking the doors with a key or remote.
The factory alarm can not be disabled. It is part of the engine and body computers. The alarm is reset by unlocking the doors with a key or remote.
Yes, just about any sensor on the engine could cause a no start.Yes, just about any sensor on the engine could cause a no start.
It is illegal to disable an air bag without written permission from the NHTSA
If a check engine light is appearing when the car starts then the ECU is receiving an alert from somewhere in the engine. The computer should receive a diagnostic test which will provide an answer as to why the check engine light appeared on the 1997 Honda Civic.
You can't legally.
It can not be disabled.
It is illegal to disable an air bag without written permission from the NHTSA.
Disable the tape player by not inserting a tape into the player.
Replace the fuel filter and use a starter fluid to start the engine.
There could be several reasons why a 1997 Ford Escort will not start. A few reasons could be the starter, the battery, spark plugs and wires, or even a blown engine.
takes 3 times for engine to start
Replace the engine coolant temp sensor.
look for the airbag fuse in the fuse box.
red lead to the larger of the two posts (positive) and negative lead to a common earth on the vehicles engine such as a mounting point or engine block. start opposing vehicle and allow to charge for 30 seconds then proceed to start the 1997 lumina allow to run then remove negative THEN positive lead.
If the check engine light is or has been illuminated, start with checking for codes.
remove stud locks