Just unplug the power wire below the motor or the fuse in the fuse box..
It is under the hood at the right rear of the engine compartment at the antenae.
Disconnect wires at antenna
Check your RPO codes. If it has an U75 than it had a power antenna. If it has RPO code US6 it has a painted fixed antenna. There was only one style power antenna used from the factory.
remove the pass. finder linner and find plug to the motor and disconnect it
gfdgfdg
To disconnect the power wire to an antenna, first ensure that the power source is turned off to prevent any electrical hazards. Locate the power wire connected to the antenna and identify the connection points. Carefully disconnect the wire by either unscrewing it from the terminal or unplugging it, depending on the type of connection. Finally, secure the disconnected wire to prevent accidental contact with live components.
Try finding the power cord that goes into the antenna and disconnect it
the antenna its self will have a connector you can unhook
To replace the power antenna on an Infiniti I30, first, disconnect the negative battery terminal to ensure safety. Remove the interior trim panel to access the antenna assembly, then disconnect any electrical connectors and unscrew the antenna from its mounting location. Install the new antenna by reversing the removal process, ensuring all connections are secure, and finally reconnect the battery. Test the antenna to confirm it operates correctly.
To replace the power antenna on a 1998 Cadillac DeVille, first, disconnect the negative battery cable. Then, remove the interior trim panel to access the antenna assembly, usually located in the rear quarter panel. Disconnect the electrical connector and antenna cable, then unscrew the antenna from its mounting bracket. Install the new antenna by reversing the steps: secure it in place, connect the electrical and antenna cables, and reattach the trim panel before reconnecting the battery.
To disassemble the power antenna on a 1992 Caprice Classic, first, disconnect the negative battery terminal to ensure safety. Then, remove the inner fender liner or access panel to reach the antenna assembly. Unscrew the mounting bolts or clips securing the antenna and disconnect the electrical connector. Finally, gently pull the antenna out from its housing, taking care not to damage any surrounding components.
To replace the power antenna shaft on a 2001 Firebird, first, remove the interior trim panel around the antenna to access the assembly. Disconnect the power connector and unscrew the antenna from its mounting point. Then, pull the broken shaft out and insert the new one, ensuring it is properly aligned. Reassemble the antenna, reconnect the power, and test it to ensure proper operation.