By Ohm's Law, resistance is voltage divided by current.
just to find out our given unknown resistance value or to put it another way, To find the value of the unknown resistor attached.
what is the diference betwean calculated and maesured value
what is the resistance value of a healthy earth pit
U didn't clearify resistance in what aspect. If u mean electrical resistance,Resistance is phenomenum which describes the limitation of the flow of electric current in an electrical circuit. According to Ohms law (V=IR),the value of resistance is directly proportional to the value of voltage and inversely proportional to the value of current.That is,as the value of resustance increased,voltage also increases;also if the valur of resistance increases,the current reduces(as in I=V/R)
It is an circuit that is used to find the value of the resistances. The main principle behind it is the balancing an circuit by means of varying an resistance on connected to an arm of the circuit.When the resistance become equal to the variable resistance no current flows thus we can find the value of the resistance.
just to find out our given unknown resistance value or to put it another way, To find the value of the unknown resistor attached.
4.8 ohms
The number of ohms is, precisely, the value of the resistance.
what is the diference betwean calculated and maesured value
what is the resistance value of a healthy earth pit
In the National Electric Code Book or in an Ugly's Electrical Reference book.
yes the R-value does indicate resistance to heat flow
yes the R-value does indicate resistance to heat flow
The resistance value for linear resistance is changed by changing the wavelength of the current or by installing additional resistors in the circuit. This restricts the amount of electricity which flows through the wiring.The resistance value for the linear resistance can be changed through strain over time. It can also be changed by changes in temperatures, such as going from hot to cold.
The plug itself will have a infinity value of resistance. If a load is connected to the plug, the internal resistance of the device will be present at the blades.
That is the value of a resistance.
we can measure the resistance of the motor by using voltmeter ammeter method of by directly using a multimeter across the armature terminals of the motor in voltmeter ammeter method we should use a less value of dc voltage to find the resistance