THE CRANKSHAFT SENSOR IS LOCATED AT THE REAR OF THE ENGINE UNDER THE STARTER MOTOR. REMOVE AND REPLACE BUT MAKE SURE THE SERFICES ANE CLEAN AND USE A NEW O RING.
there are some gait ones that fit
Yes! 1995-1999 yes it will fit but if you live in states that require inspections it will not pass because of the crank shaft sensor will not be picked up. been there done that!
NO! 17 wheels do NOT fit a corsa
any type of head except for a crank shaft head because it is bent. But any kind of head should fit.
Sensor is a push fit into the flexible pipe between the air filter box and the engine inlet.Just unclip the wiring connector and pull it out.
no thay are coded to the car
It will be in the air duct between the air filter and the engine inlet.Probably a push fit into a rubbery boss.One wiring plug on it.
17" will fit!! =)
where is the speadometeter cable on an x reg corsa
if the corsa's are of close age then the 1.8 box will probably fit the 1.6 engine if the engines are similar design and the main different is just the displacement
Yes but the 95 bell housing will need to be reused to the crank angle sensor can be retained
it will fit on shafts make sure the shaft is mens and it's a little harder to put on a crank shaft. if this is a real problem take it to the nearest lacrosse store and ask them why and if i burned out of shape go to where you bought it and see if you have a warranty (most heads do)