Brake lights go through the turn signal switch. When you hit the brakes, the brake lights come on but if you turn on the signal at the same time, that side brake light is controlled by the turn signal.
If you're certain that the bulb is good and has been properly installed, the only possibilities are, faulty bulb socket, bad electrical connection or turn signal switch inside the steering column... and BTW, it can be a real pain to replace, depending on the vehicle.
HeadlineI actually switched bulbs from the working side to the non working and vice versa, still same thing.And on the 92 Accord, there's separate bulbs for the tail/brake lights than it has for the turn signal. I guess it still could be in the turn signal switch, but this seems to throw another wrinkle into the equation.
I'm hearing a clicking sound inside(away from the brake light switch) like a relay clicking off and on. Any thoughts on if/where a brake light relay might be?
Thanks in advance for any extra thoughts/input.
Have you checked the fuse? I always check that first. :-)
When it happened to me it was the wiring and the little box next to the bulbs (sorry I don't know what it is called it is right next to the brake bulb on the plate side. ) that were the problem. The connections and the box were badly corroded. From the outside they looked fine but when I went to unplug the little box everything pretty much fell apart.
I just went to the auto recyclers found the same car and cut out the entire assembly from the car. I cut it where the wires went into the tail light so I had the two sockets and the box. I spliced the "new" stuff to my car and it worked. I cut it further back than just at the plug and the box because someone had worked on the wiring before and did a crappy job. I am not a mechanic and it only took me about a half hour to do the whole job once I got it home.
Good luck!
i have a 1995 Honda accord 4 cylinder v tec the tail lights sides lights and the dash lights stays on at all times have already replaced the headlight switch and still have the same proplome
it dont have lights
hazard switch dont lights on
either the switch is not working or a wire to the switch is broken
Turn signal relay needs to be replaced. If you turn on the hazard (emergency) switch, all the signal lights should come on. This says the lights are okay.
check your fuses ... assuming that only the lights failed. Second posibility: the switch or the wires going to the light switch.
CHECK FUSABLE LINKS AND THE IGNITION SWITCH.FOR 12VOLT REF
If the high beam switch is broken that it should be replaced. When the unit is replaced the high beams will work again.
Check bulbs Check fuse Check switch
Switch on brake pedal needs tightened replaced, or switch for lights needs tightened or replaced.
could be bad wiring
Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.