Well most cars these days have little clips or 'slots' in which the bolts are usually fastened to to keep the bumper together. If one of these bolts happens to break of and go missing you can fasten some wire or even a Bobby pin to hold the bumper on as a short term resolution.
I believe it is under the vehicle, in back, directly in front of the fuel tank.
If it is anything like my 2001 Ford Escape XLT you have to remove the bumper. or at least loosen enough to get to the headlight straps. My husband and I just changed the bumper, grille, and drivers fog and headlight assemblies (we hit a deer and deductible was to high). Our headlight had four bolts holding it in and 2 electrical plugs. Simple job when the bumper is off. The bumper has two bolts right under the hood, seven underneath, two snaps under the license plate, three in each wheel well and one where the bumper meets the fender (kind of a bugger to get at this one but we did it). It took us about 4 hours. We aren't mechanics but have done a few small projects before.
Computer controlled
There's a small sensor on the transmission that the size of a spark plug.It's on the driver side of the transmission near the shift linkage
The front wheels have abs sensors if applicable. The sensors would be mounted to the spindles not the rotors.
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
The front bumper for a Lincon Navigator cannot fit in an F150 2001 SVT.
The 2001 Ford Escape has 40.4 in. of front head room.
The 2001 Ford Escape has 41.6 in. of front leg room.
The 2001 Ford Escape has 53.4 in. of front hip room.
The 2001 Ford Escape has 56.3 in. of front shoulder room.
how to 2001 highlander grille
how do you screw off front bumper to a land rover discovery 2001
what size is the nut holding the front hub on a 2001 ford escape
The 2001 Ford Escape has front wheel drive.
It is up by the front bumper, Close to the radiator.
yes it will