Remove the inside door panel to observe what is broken/disconnected
To remove pop off the top plastic cover. Pop off the door handle and power window covers. Next you will need to remove 4 screws. One at the top of the door that was behind the plastic part, one at the lower corner of the door behind a little round screw cover, and the last 2 are holding the door pull to the door.
Now you will need to slide the panel straight up it has to go up to get it off.
+++++
The most common failure is a fitting on the latch cable that engages with the latch, The fitting is made of plastic and it dry-rots and crumbles. It looks sorta like a cigarette holder with a groove around it, and it holds the cable stationary while a small ball on the end of the cable actuates the latch itself. There's an aftermarket product made that will work but it's a pita to replace. Try to locate a new latch cable. Either that or buy the entire latch assembly, which I'm pretty sure is a dealer-only part.
Most likely the outside handle is broken. The ear that the rod connects to breaks off. Only solution is to replace. Remove the inside panel and there will be one or two bolts holding the handle in. ON the back door there should only be one rod connected to it.
Inside handle, outside handle, sliding door handle?
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
take inside door panel off and unbolt outside door handle from the inside.
Inside door handle or outside door handle?
Need to know if it is an inside or outside door handle.
Need to know inside or outside door handle.
= outside door handle on a 1997 Toyota Camry. =
you must use a wedge on the outside above the handle to see inside and then use a coat hanger or something long to pull the handle rod
nothing
you have to take the door panel off the inside first
Inside or outside?