0
How do you fix your speedometer on your 1990 Oldsmobile cutlass?
Wiki User
∙ 14y ago
May have to take it to a certified speedometer repair shop
Wiki User
∙ 14y ago
Anonymous
U
Add your answer:
Earn +20 pts
How do you fix a slipping transmission on a 1990 Oldsmobile cutlass SL?
you must change out the tourqe converter or hydrolic kit on trans.
How do you fix the speedometer on a 1994 olds 98?
You can fix the speedometer in your 1994 Oldsmobile 98 by replacing the speedometer cable. If changing the speedometer cable does not fix your speedometer you will need to replace the entire speedometer.
How do you fix a bad speedometer cable pm a 1992 cutlass?
u buy new wireing for it
How do you fix a noisy speedometer on 1982 Olds Cutlass?
Sounds like the cable needs to be lubricated
How do you fix a 93 cutlass supreme Oldsmobile?
be more specific money, lowrider, race car,or in what way..
How do you fix speedometer on 1990 delta 88?
I'd suggest you take the car to a speedometer repair specialist. They can remove, repair and calibrate the spedometer.
How do you fix an electric window that has power going to it on a 97 Oldsmobile Cutlass Supreme?
apparently the window motor is bad and will need replaced.
How do you fix the speedometer on a 93 Oldsmobile ciera when speedometer and odometer is in-op?
Its a fairly simple fix. On top of the tranny, on the back side, is the speed sensor. Replace this, and everything should be working again. The part can be had at any of your local parts stores.
How do you fix a speedometer on a 1990 Buick?
replace the sensor which is usually in the rear diffrential or the transmission case
How do you fix the soft seal on your 1990 Oldsmobile 88 royal?
What is and where is the soft seal located?
How do you fix a 1988 Oldsmobile cutlass supreme dashboard lights that want stay on?
Replace headlight switch- dimming rheostat may be loose
How do you fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2 door?
To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.
