You must remove the plastic panel located under the windshield wipers. There is about 5 or six torx screws under the hood and about as many Phillips screw hid by plastic covers across the panel.
On a 2000 Mercury Cougar the windshield washer fluid reservoir is at the front of the engine compartment , near the passenger side headlight
Yes , the 1999 Mercury Cougar is FRONT wheel drive
No , a 1994 Mercury Cougar is rear wheel drive
On a 2001 Mercury Cougar : The radiator is located in the engine compartment , at the front of the vehicle
On a Mercury Cougar : ( 1999 to 2002 model years are front wheel drive ) Older model years are rear wheel drive
It's grounded on the front of the Mercury Cougar frame next to the headlight assembly.
On a 2001 Mercury Cougar : The fuel pump shut off switch ( inertia switch ) is located in the drivers foot well behind the kick panel ( there is an access hole ) * the kick panel is the interior trim panel , in front of the front door , beside the persons feet
no it is defently rear wheel ================================================== That would depend on which model year , there have been rear wheel drive and front wheel drive versions of the Mercury Cougar
the front bearings on the 1989-thru-1997 ford thunderbird/mercury cougar cannot be changed, the whole front hub comes as one piece and have to be replaced as a single unit.
They are 5"x7" front ant rear, http://www.modifiedlife.com/1991-mercury-cougar-car-audio-wiring-schematic/
You can find a front door latch assembly diagram, for your 1996, Mercury Cougar from the manufacturer website. Many auto-parts websites will have the diagram.
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.