If it's the brake light in the boot lid then you have to take the cover off the inside of the boot lid and then you will have access to the light bulbs. If it's the brake light in the rear quarter panel then you open boot lid and unscrew the two bolts holding the light cluster and slide it backwards, then you will have access to the bulbs
It is possible that the wear indicators for the brake pads are touching the rotor, indicating worn brake pads. They probably make the noise all the time, but at higher speeds, the pitch changes, and there is more road noise, so the problem is less noticeable. Depending on how much you drive, and traffic situations, etc, the noise should get a lot more more noticeable within the next couple of days. You will then have to replace the brake pads, ASAP. If not, the pads will tear up the rotors, and then they too will have to be replaced.
Most likely the plates or discs in the transmission are stuck together. There is really nothing to be done but repair or replace the transmission. I assume this is an automatic. They tend to fuse together so additives do not help.
have your brake rotors turned on a lathe, or replace them with new ones.
Open trunk and remove screws that secure light assembly to car. Pull assembly straight back to remove from car. Remove the dead light and replace with proper new light. Install in reverse order of removal.
If you're changing the brake pads and there is too little rotor thikness to turn it, it should be replaced. If the rotor is warped and is too thin to be able to turn to remove the warping, replace it. If the brakes "pulsate" when you use moderate brake pressure, the rotor is warped.
Where is the brake fuse on a 1990 Toyota previa
Replace the light bulb. Tail lights are usually dual filament, 2 filaments in one bulb.
how to replace brake fluid on a 1999 Toyota 4runner
dot 3. nothing fancy always add brake fluid from a sealed container. It absorbs moisture.
Replace the caliper, it is probably stuck. Take the brake pads off and check the wear pattern. If you are unable to tell take them to the autoparts store, they should be able to help.
I need timing mark for Toyota paseo
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
brake light switch above the brake pedal
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
Pop up the driver seat, and it's right next to the parking brake. It's square and sticks up.
only toyota could be this stupid and incompetent...
How do you replace the front break pads on a Toyota corolla .