0
You loosen it with a long 'breaker bar', without power tools I don't know of any other way.
If you have clearance and parts like the radiator and shroud out of the way, you can position the breaker bar on the bolt with the breaker bar laying over on the drivers side up against the frame then with the coil wire removed jog the engine over with the key and the bolt will break loose. I've done this in a pinch.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you loosen a crank shaft bolt?
With the proper tools and the correct torque.
Which way does the crank pully bolt turn off on a rav 4?
It turns off left. But it is almost impossible to do without an impact wrench. To get it off without impact tools you need to find some way to keep the engine from rotating as you turn the bolt. That bolt is in there pretty tight and almost any method you try to hold the crank pulley is going to cause damage when you try to crank that bolt loose. Suggest you check with a local rental outfit and rent the compressor (if you don't have one) and the necessary impact wrench and socket. Good luck.
How do the crank bolt come out?
Use an impact gun or secure flywheel when loosening crank bolt.
Will a 2 bolt crank fit in a 4 bolt?
yes
On a 1990 Acura Integra RS is the crankshaft pulley bolt reverse thread?
No - The crankshaft bolt will loosen counter-clockwise. Because the crank bolt is so hard to remove it can seem as though it is reversed threaded. The crank turns the opposite direction that is used to tighten the bolt. For the crank bolt Lefty-Loosey (counter clockwise), Righty-Tighty (clockwise) apply here. The crank bolt is tightened to 87 ft/lbs of torque. It took more then 87 ft/lbs of torque to loosen my crank bolt. The manual says to apply a drop of motor oil when reinstalling the bolt. An Harmonic Balancer Pully Holding Tool is used to hold the crank while working with the crank bolt. Holding Tools can be found on the internet for $20 to $73. There are two sizes, 45 mm and 50 mm. For a 1990 model year the size is 50 mm. I made an Harmonic Balancer Pully Holding Tool by tack welding a 2 foot length of 1 1/2 inch by 1/2 inch piece of stock, for a handle, on a 2 inch (50 mm) hex nut. The nut fits into the pully to hold the crank and the socket, used to turn the crank bolt, fits through the nut.
How do you turn over an engine by hand on a 2001 Chrysler sebring convertible limited 2.7?
A ratchet and socket on the bolt that holds the crank pulley on.A ratchet and socket on the bolt that holds the crank pulley on.
How do you hold crank while trying to remove crank bolt?
use impact gun or use the the starter to loosen the bolt with a long Johnson bar or ratchet.
What size is the crank pulley bolt on sr20?
27mm
What actors and actresses appeared in Eat-Man - 1997?
The cast of Eat-Man - 1997 includes: Masashi Ebara as Bolt Crank Anthony Rocissano as Bolt Crank
Where is a crank sensor located on a 2002 wrx?
Under the alternator above the crank pully. 10mm bolt.
Can the Kia Sorento crankshaft pulley bolt damage the crank sensor?
Others have had problems with the crankshaft pulley bolt on their Kia Sorento damaging the crank sensor. This can happen if the bolt breaks. The timing belt can be damaged as well.
Is the bolt for the crank pulley L or R hand thread on a 96 Geo Metro 4-cylinder?
The crank bolt is right thread on a 96 geo metro. bob.
