answersLogoWhite

0


Best Answer

If you are speaking of the inner c.v. joint for one of the front axles there is an internal snap ring that has to bee removed to get this joint out,just slide the c.v. boot back and look at the inner edge of what the joint slides in to and you can see it.

User Avatar

Wiki User

โˆ™ 2006-10-21 23:11:27
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you get the inner joint out of a 1996 Honda Passport?
Write your answer...
Submit
Related questions

Where is the fuel filter located on a 1996 Honda Passport?

The fuel filter on a 1996 Honda Passport is located underneath the vehicle close to the gas tank. The filter will have bolts holding it in.


Show location of coolant temp sensor on a 1996 Honda passport?

The location of the coolant temperature on the 1996 Honda Passport is actually behind the alternator. You can see the sensor in any Haynes or Chilton's manual for that vehicle year.


How do you remove the oil filter on a 1996 Honda passport?

Turn it counterclockwise.


Where can you get a diagram for a 3.2L V6 motor for a 1996 Honda Passport?

A diagram for a 3.2L V6 motor for a 1996 Honda Passport can be ordered from any Honda dealership. You will want to check with your local dealer and see if they can get you one free of charge or if there is a fee. They may even have one that you can borrow.


1996 Honda Passport heater blower doesn't work?

Buy a Toyota


Location of starter on Honda Passport 1996?

Look at the lower rear end of the engine


What type of oil for a 1996 Honda passport?

SAE 5w-30 any major brand.


Where is the transmission dipstick located on a 1996 Honda Passport?

doesnt have one it is a sealed non serviceable unit


Where is the starter located on a 1996 Honda Passport?

Follow the red battery cable down from the battery to the starter.


What size engine was used in 1996 Honda Passport?

it's a 30l, with a dual over head cam...


How would i find an owners manual for a 1996 Honda Passport?

i want to print a free owners manual


Where is the drain cock on a 1996 Honda passport?

Should be at the bottom or rear of the radiator or remove lower radiator hose


How many quarts of oil go you put in a 1996 Honda passport per oil change?

5.7 quarts


Ignition switch 1996 Honda passport is locked car will not start?

if the battery is dead the switch wont unlock or start


Is it bad to flush transmission fluid in a 1996 Honda Passport?

Yes. http://forum.planetisuzoo.com/viewtopic.php?t=24731


How do you remove the center cap on a 1996 Honda Passport?

You must remove the wheel because there are scews that hold it onto the inside of the wheel.


Where are the starter solenoid contacts located for an 1996 Honda Passport with a 3.2 liter V6 engine?

The starter solenoid is mounted on the side of the starter.


Why no power to starter when you turn key on 1996 Honda Passport?

Check the park/neutral safety switch, or clutch switch if its a manual.


Where is the water pump located on a 1996 Honda Passport?

It is behind the timing belt coves and you will have to take the timing belt off to change the water pump out


What does trouble code p0463 mean for Honda Passport?

For 1996 and newer Trouble code P0463 means:Fuel level sensor circuit high input


Why does it seem like the 4x4 is slipping when I engage the 4x4 is a 96 Honda passport?

The 4x4 slipping means that the transmission for the 4 wheel drive is not engaging like it should. The 1996 Honda might need to have the trans-axle repaired.


What could be a problem if you don't have lights in AC-heater copmartment in 1996 Honda passport?

the bulbs that illuminate that section of the dash have most likely burned out and will need to be replaced


Do you need to disconnect the AC to replace the heater core on a 1996 Honda Passport?

you should only have to take loose the heater hoses where they go into the firewall and of course the heater core itself


How do you replace CV joints on 1996 Ford Aerostar?

The CV joints on a 1996 Ford Aerostar can be replaced by removing the nuts and bolts on the tires. Next, cotter pins, lower ball joints, and the outer joint will need to be removed. Then a pry bar can be placed between the transmission and the inner joint, which will make it easy to pull out.


Does a 1996 Honda Accord radiator fit a 1996 Honda Accord LX?

Yes