did you try to loosen the bleeder screw before using the c clamps You have to turn the piston clockwise in order for it to go back into the caliper.
The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper. The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper.
If the piston has come out, the caliper will need replaced.
There are two reasons i know of . first the oring in the piston is either cut or twisted. The other is that the o ring on the piston is to small. The only cure is to replace it either way.
When installing new pads, push piston into cylinder body by gently turning piston clockwise,with long nose pliers, or suitable tool
Have noticed that Ford still uses the screw style pistons on the rear calipers. To retract the piston use either a caliper/piston tool or a set of needle nose pliers. Turn the piston clockwise to get it back in but take note of the position of the grooves as they normally need to align so that a imaginary straight line through the grooves points to the center of the caliper.
You can use a large C-Clamp to compress the caliper piston.
Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body If parking brake is used on this caliper piston is threaded and a special tool (not expensive) is required to thread piston into caliper body
Dual piston caliper, 85 ft lbs. Single piston caliper, 37 ft lbs.
Yes, you need to remove the caliper first, then use the old brake pad and a C clamp to push down the piston of the caliper.
If it is the front brake use a "C" clamp to retract piston If it is the rear and the parking brake is used by this caliper piston is threaded and a special tool (not expensive) available at Sears or auto parts to "screw" piston into caliper body
There is a specialty tool for this procedure. There is a metal plate that fits on the piston, then a clamp for the back of the caliper. Turning a screw will pull in the caliper. Opening the bleeder valve may be necessary.
Hydraulic force, transmitted by the brake fluid.