answersLogoWhite

0


Best Answer

twist oil filler collar (below the cap) counter clockwise about 1/4 turn, it will then pull out. Then pull rear end of plastic cover tab out of the hole that it "plugs" into, and lift cover off. All that holds it on is the tab sticking into the hole at the back, and the oil filler collar at the front.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get the plastic engine cover off the engine on a 3.8 v6 Chevy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil plug located on a 2005 Chevy Trailblazer?

Oil pan, bottom of engine. There is a plastic cover over it. Take off the small plastic cover.


Where are spark plugs located on 2005 Chevy Cobalt?

take off the plastic cover and under where the silver cover on the engine says ecotech is where the spark plugs are located


How do you remove the top engine cover plastic cover on VW Golf V5 mark 4 please?

Pull it off


Where is the intake plenum located on a dodge charger?

It's directly underneath the plastic cover that covers the top of the engine, the plastic cover pulls off and the intake plenum is underneath it.


Where is a tcc soleniod for Chevy venture for Chevy 2001 venture?

It is inside the side cover of the transmission. The frame / engine / trans. wil need to be lowered to get the cover off. Tech JK --------------------------------


How do you get plastic engine cover off 2007 Dodge caliber 2.0?

grab both sides and pull firmly


Where is the oil filter on a 2009 Hyundai sonata v6?

On the top of the engine. (take off the plastic engine cover) It is in a black plastic housing that screws off. You have to buy the paper filter and 2 o rings from the Hyundai dealer.


Where is the knock sensor on 2003 Chevy Tahoe?

there are two under the air intake system on top of the engine. you will need to take the air intake off as well as the plastic cover. be sure not to get any dust in your mass air flow sensor.... i did.


How do you replace the headlight bulb located on a 1996 Chevy Silverado?

open the hood and there is a bracket with 2 screws take that braket off the take off plastic cover then you can do the job


What gaskets do you need for installing cam on Chevy big block engine?

water pump, intake, timing cover and valve cover if you tear them up taking them off


Where is the fuse box in 2004 Chevy Tahoe?

Under the hood on the right side as you're looking at the truck. It is in a black, plastic box. The cover just pulls off and there is a diagram on the underside of the cover.


How do you remove the plastic cover to change the rear tail light on a 1997 Chevy S10?

the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side