0
How do you get the spark plugs out of a Buel XB9S motorcycle without pulling the motor?
Wiki User
∙ 13y ago
Take the left side air vent off. Use a 5/8 socket and a 5/8 wrench and work the front one out.
The rear one you go in from the left side with a 5/8 socket, swivel, and a 6 inch extension. you can reach up under the frame with your left hand where you took the air vent out and guide it in.
Use a piece of fuel line to guide the new ones in without cross threading them.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can you change your freeze plugs without pulling the motor?
It is impossible to do it you have to pull the engine
Are the freeze plugs on the back of the Chevrolet 350 motor repairable without pulling the transmission?
NO THEY ARE NOT.
Can the freeze plugs on the back of the suburan Chevrolet 350 motor repairable without pulling the transmission or the motor?
No way, one are the other has to be taken out to repair.
How do you gap the plugs for a Chevrolet 1993 350 motor without a tool?
you can use a dime and get close.
How do you fix wii Black screen without sending it into nintendo?
You can fix Wii Black screen without sending it into Nintendo by pulling out the plugs at the back, and re inserting them.
How do you change freeze plugs on a 2.8L motor in a 86 firebird and due you have to take out the motor and transmission?
They can usually be pried out with a screwdriver and knocked back in. Most can be got to with the motor in place somehow. The 2 in the back of the block require either the motor or trans. to be pulled. For me, pulling the motor requires less effort. Less wiring and plumbing.
What size socket to remove plugs from 750 Honda ace motorcycle?
You will need a 5/8 socket to remove the plugs from your 750 Honda motorcycle. A deep well socket is recommended.
Replace ford bronco lock motor?
first what made the motor lock up, and what kind of motor is it , it could be alot of things like no oil, the trans, if its fuel injection and you put gas in the intake to try and start it this would lock it down as well. try pulling the spark plugs and turning over the motor.
How do you change spark plugs on a motorcycle?
Take the wire off of the spark plug by pulling it straight out. Find a deep socket that will fit the spark plug and turn it counter-clockwise. Go to the motorcycle shop and show them the spark plug you took out and tell them the year, make, and model of your bike. Reverse order to put back in.
How do you start a motorcycle that has been sitting for a year?
Remove spark plugs Put some Marvel mystery oil into cylinders Manually turn engine over a few times Instrall plugs Change Motor oil Re-fresh fuel Install a fresh battery
How many spark plugs on a 1987 Honda Aspencade motorcycle?
4
Can you reprime the oil pump on a 1988 Buick Park Ave 3800 without pulling the timing chain cover?
Absolutely !!! Pull the spark plugs (removes drag from the starter) and crank the motor for a minute or two. Engine builders often do this very thing prior to the initial firing of a new engine. TRY PULLING OFF OIL FILTER AND PACKING IT WITH A LIGHT GREESE PACK IT GOOD
