Drop the steering column and you will see the clip that retains the switch to the brake pedal shaft, the switch also clamps on to the linkage that goes to the master cylinder. Pop the clip on the brake pedal, swing the switch down off the linkage and slide it to the left and it will come off. If the switch was not clamped to the linkage this will cause the switch not to work. I've also found the slightest amount of play on the shaft will cause it to work intermitent, wrapping the switch in place with packing tape works great.
need a wiring diagram for a 94 chev cab for the brake light switch
brake and abs light on , on 1994 Chevy Cavalier Z24
Brake Lights Stay on Unless the Brake Pedal is RaisedThis is usually caused by the brake light switch being out of adjustment in its physical distance to the contact point on the brake pedal arm.
on your brake pedal lever.
The 1994 Toyota Camry emergency brake light switch can be found beneath the drivers side dashboard. The emergency brake light switch will be beneath the far left hand side of the dashboard.
The brake light switch is typically under the dashboard near the top of the brake pedal arm.
there is a switch up under the brake pedal
On the brake pedal assembly.
It's just above the brake pedal, connected to the brake pedal arm. The switch comes out with two screws and the new one plugs in. But before you replace the switch, check the adjustment.
Check for a loose connection Check for a loose fuse in the fuse box Check for an open wire in the brake light circuit
Yes. One switch is for the left and right brake light assemblies; and, the other is for the 'third' brake light.
If you mean the brake light switch (tail brake light) , is in the upper part of the brake pedal. Just follow the brake pedal up and you will see two rubber buttons(switch stopper) and their respective switches, those are for the brake light switch(left) and the cruise control(right)