very simple, three screw you must take out. the front outside(phillip screw driver) and the two screw on the side(hex driver)
you have to remove the headlight assembly 3little bolts
This was answered last week and is a simple procedure. One Phillips screw holds the parking light on in my 2000 Forester. You open the hood, remove the screw, pull the lamp assembly out and you have access to change the bulb. If you are asking about changing the whole assembly, the answer is the same. --Ken
I believe it is 2 torx screws inside the tailgate holding the assembly. Have to replace the whole assembly.
Remove the headlight assembly and you will have access to the parking light bulb.
If you cant change it it's broken. Regards cemalig
how do i change a parking light bulb on a 2003 hyunadi accent
THERE IS NO PARKING LIGHT LENSE FOR THE REAR. IT'S ONLY THE TAIL LAMP ASSEMBLY!
Remove the headlight assembly to gain access to the parking light socket/bulb.
I can't remember if the parking lights are inside the headlight lens assembly, so try the "Related Questions" below - see if they'll get you started on the right track.
For the rear light assemblies there is one screw. Open the hatchback and on the inside top edge of the assembly, remove the one Philips head screw. You will also see a couple of slots next to the body. Stick a flat blade screw driver into these slots between the body and the light assembly and pry out on the assembly. It will pop out from the body.
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA
Front of the car, built into the headlight assembly. It is the orange light nearest the tire.