Going through the same thing on a 89. Pull the front of the dash off above the steering column. There are 4 screws holing in the gage cluster. Undo them and pull forward, then disconnect the cable from the gage cluster. Note: the (speedo) cable is just clipped to the instrument panel a good yank is all that is needed to remove the speedo cable.
Back in 1991 I THINK that they still used a mechanical cable from the transmission to the speedometer. Only later did they change to electronic readout, but I'm not sure what year. It sounds like the speedo cable needs to be lubricated, possibly replaced.
The speedometer is cable driven.
The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.
Where is the oil filter located on a 1991 toyota pickup
Kickdown cable needs adjusting.
I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup
A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.
Yes , I BELIEVE the last year for a speedometer cable on a Ford Explorer was the 1995 model year so the 1991 Ford Ranger would definitely have a speedometer cable
Sounds like the speedo cable may have snapped www.mr2-ben.co.uk Toyota mr2 mk2 New & Used parts
tranny cable?
The cable is manual drive on a 1991.It plugs directly in the back of the speedometer.
changing front brake pads on 1991 Toyota truck