answersLogoWhite
Chevy S-10
Plymouth Voyager
Nissan Sentra

How do you get trouble codes for a 1997 Plymouth Voyager?

171819

Top Answer
User Avatar
Wiki User
Answered
2008-01-19 03:25:04
2008-01-19 03:25:04

Turn the ignition key off and on three times. You will see the check engine light go off and on. Count the times the light goes off and on. Those are the codes.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


what do I need to change the 1997 Plymouth voyager transmission oil


A 1996 or 1997 Dodge caravan or Plymouth Voyager with the same engine size will have the same transmission.A 1996 or 1997 Dodge caravan or Plymouth Voyager with the same engine size will have the same transmission.


Where is the water pump located on a 1996 Plymouth Voyager?


The under hood fuse box is next to the battery on a 1997 Plymouth Voyager.


how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l



After reading the code, and repairing the codes, you reset code with a scan tool.



On a 1997 Plymouth Voyager, the relay for the rear wiper is found under the hood. It is in the fuse housing on the passenger side.


The fuel filter on a 1997 Plymouth Voyager is mounted above the onboard edge of the fuel tank.


Trouble code P0353 means:Ignition coil C primary/secondary circuit malfunction


Plymouth does not use inertia/reset switches


Plymouth does not use inertia/reset switches



The 1997 Plymouth Voyager low pressure valve is located on the bottom of the air conditioner compressor. The low pressure valve has a hose connected to it.


I don't know---does it? Get literate!


The 1997 Plymouth Voyager 3.0 liter engine coolant capacity is 5.5 gallons. The coolant should be at a minimum of 50 percent antifreeze.


The size of lug nuts on a 1997 Plymouth Voyager is a Hex Size of 3/4 inches. The length of each lug nut would be 1.45 inches.



were is the cooling temperature sensor located on my 96 Plymouth grand voyager


A transmission that is sticking would cause a 1997 Plymouth Grand Voyager to die after shifting it into gear. A problem with the ignition system could also cause this.


Plymouth vehicles do not have inertia/shut off switches.






Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.