0
The proper way to grease a slip yoke is to unbolt one end of the driveshaft. Drop it an puii the yoke apart. Coat the splines with grease and reinstall.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Is the rear transmission sealed on the outside of the slip yoke?
the slip yoke goes into the rear transmission seal
What is slip yoke drive shaft?
A slip yoke is when the end of the drive shaft in a RWD vehicle plunges in and out of [most likeley] transmission when rear suspension is flexed.
99 silverado transmission hesitates when taking off?
could be the slip yoke needs greased. call your local GM service dept. and ask which grease to use as i can't remember right now.
What is the difference between a slip yoke and flange yoke on rear of transfer case?
A slip yoke has a splined shaft the drive shaft slides over. This allows the drive shaft to flex on rough terrain. A flange yoke has a flat plate on the transfer case and the end of the drive shaft and they bolt together.
What causes a carrier bearing to push out?
The rear section of the driveshaft has a slip yoke in it. This allows the rear section of the driveshaft to change length as the rear axle moves up and down. If this slip yoke binds, the change in length is absorbed by the slip yoke at the back of the transmission. Because the carrier bearing itself is fixed to the driveshaft, and the hanger that holds the bearing is fixed to the frame or cross member, when the rear slip yoke binds, it moves the entire driveshaft forward taking the carrier bearing with it, and pushing it out of the rubber in the hanger.
Where should slip yoke be on ford bronco 6 lift transfercase or rear axle?
The slip yoke on the Ford Bronco is located on the rear axle rather than on the transfer case. This is the portion of the axle that allows it to flex.
On a rear wheel drive car what is the purpose of the slip yoke on the driveshaft where it enters the rear of the transmission?
the purpose of the slip yoke is to allow for movement over bumps and different terrain. if there was no give ,you would constantly be trashing the driveshaft or transmission
Is the front drive shaft of a 1987 Chevy v10 spring loaded?
NO. It has a slip yoke.
What supports the slip yoke of a one piece drive shaft assembly?
The tailshaft housing and bushing
What would cause a 1999 Chevy Tahoe's transmission to bump and slip when pulling out?
My trans had that problem and it was the yoke on the drive line going into the rear trans needed lubrication takes about 15 minutes to do disconect drive line u joints at rear end and slide drive line out and lubricate the splines that go into transmission with grease a heavy bearing grease worked fine for me.
How do you tell what auto trans is in 2006 f 250 4x4 diesel?
motorcraft . com shows it as being a version of the ( 5R 110W ) automatic transmission It lists 4 different versions with the 6.0 L diesel With slip yoke , without slip yoke , and I assume 2 wheel drive or 4x4
Do 2005 jeep wrangler unlimited come with slip yoke eliminator kits?
Only if it was installed aftermarket, they do not come with them from the factory.
