Running all these speakers at the same time might damage the amplifier. There are switchers made to handle this task.
You do not receive a receiver to hook up speakers to your tv. An jack that contains the speaker to your TV is all that you need.
The speakers and subwoofer plug into your receiver.
Run the audio through a receiver and speakers. Most receivers will let you hook up headphones and the speakers can either be on or off.
Audio out (line out) from the Home Theater to audio in (line in) on the Power Amp. If you use Preamp out on the Home Theater the Volume Control will control the volume of the Power Amp and Speakers.
Depends on what your definition of "receiver" is, but most of the time - to the amplifier. Consider: if the receiver is some form of a device that receives some signal, and then decodes it to audio, then the receiver will hook into the amplifier, which in turn will drive the speakers (so the speakers go to the amplifier) if, on the other hand, the receiver is a part of a wireless connection between the amplifier and speaker, then it really serves the role of a cable, so in essence you're again connecting the speakers to an amplifier (only using the receiver as an intermediary) You would have to specify your case.
The familiar red and white RCA jacks are needed to hook your Direct TV receiver up to an audio source.In general you'll need a stereo receiver to hook it up to speakers.You do get superb audio from DTV so it's worth the trouble.
Nope.
actually you can. you can also put it in a radio if you have the right wires.
yes if you run them in sequence.receiver to #1-#1 to#2-#2 to #3 and so on.however sound quality will be affected.not recomended.
For most home theater setups, all you really need is an RCA cable to connect your TV to the stereo receiver.
It is absolutely possible! If the instructions that come with the speakers are not clear enough, most electronics companies have step-by-step guides on their website.
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.