Sorry buddy but i work in that and...answer is no way.there is no tools that you could have some kind measuring tools that could help you.
Only way is that you ask your supplier/producer of fittings and ask him a catalog where you could find your specified fittings.
The high pressure line is a high pressure hydraulic line. The can leak from the attachments to the fittings. The will leak where the line is damaged Or if it as a very old line they can crack.
Fittings are parts used in plumbing and other pipe systems to connect parts. The name comes from how they 'fit' pipes together. Hydraulic fittings are much stronger than most fittings due to the high pressures they must withstand.
False (no)
The hydraulic system works is dangerous. If the holes are pressure hoses transmission oilis sprayed with high pressure and this is very dangerous.
not quite, it depends on the pressure of system, but hydraulic tends to be high or could be very high pressure, and pneumatic is often lower pressure. the low grade rated pressure hose/ pipe would fail and burst/ causing injury.
The hydraulic system are provided auto system and high level pressure control, and safety for operating system
You should consult with a tractor manufacturing company. Or high-pressure hydraulic oil to use.
one reason air is much harder to control the heat and air has a lot of water in it and a hydraulic system dose not need water in the hydraulic oil. There is no way at the high pressure that a hydraulic system has to work at,it would not be possible to control the heat.
Firstly you need reservoir for hydraulic oil from there goes one line to inlet port of hydraulic pump (which is driven by a engine or electric motor) then the high pressure port from hydraulic pump goes to hydraulic steering orbitrol, which is connected by a shaft to a steering wheel and has usually 4 ports. One port is connected to a pressure port from hydraulic pump (high pressure). Second port is return line to a reservoir (lower pressure). The other two ports are lines that goes to a hydraulic steering cylinder (which delivers the turning force to steering wheels). Operation: When the hydraulic pump is running and has pressure on outlet port the hydraulic oil flows through hydraulic steering orbitrol and back to reservoir. And when you apply turns to a steering wheel the hydraulic steering orbitrol redirects specific amount of hydraulic pressure to a hydraulic steering cylinder and there you have a turning force. -_- max
Hydraulic is used in terms to define liquid. Hydraulic mining in the ole days was used by high pressure water. Hydraulic lines contain oil for cranes, booms, etc.
Perhaps coupling and clamps, but always better to replace. A shop fitted with the proper equipment to make hydraulic hoses can.
Trans cooler lines are pressure, but not HIGH pressure. The fittings are either connected with a tube nt, or a quick connect fitting. There is a tool available for this fitting(if you are doing numerous vehicles the tool is worth the money, but the spring clips CAN be picked out and re-installed.