Auto Parts and Repairs
Dodge Durango
Mazda Protege
Windows XP

How do you install a CD player on a 94 Mazda Protege?


Top Answer
User Avatar
Wiki User
2015-07-15 21:16:52
2015-07-15 21:16:52

there should be a plastic base plate that goes around the factory receiver held in my clips. by pulling directly out toward the backseat that should easily slide out. then there will be 4 screws holding in the factory receiver, remove those as well as screws holding in the plastic dummy place also in there. you can purchase a bracket that will screw into the preexisting holes and mount your aftermarket receiver into that brackett

hope that helps


Related Questions

need to know what wire go were for a 94 Mazda protege MAF sensor

If your heater does not work on your 94 Mazda Protege, check the thermostat. You can also check the heater fuse to ensure it has not blown.

It does NOT have airbags. However, it is a very dependable little car and has great value

There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.

how du you replace a thermostat in Mazda pickup b2300 94

i need to change my alternator belt and don't know where the tension wheel is so i can take off the other belt to replace the alternator belt on my 94 Mazda protege 1.6l

if you are flushing the radiator instead of topping it up. you need to buy a gallon of it and dilute it with clean water. read the instruction and follow.

The size of front speakers on a 94 Mazda 121 are 130mm.

i was told by a technician that you turn the cilynder itself, and it would go back in... i tried this myself, and can still not get it to go in.. aynone heard about this?

i drive a 94 Mazda mx6 and the answer to your questions is it takes 4 quarts of oil! i drive a 94 Mazda mx6 and the answer to your questions is it takes 4 quarts of oil!

fifth gear and the related components need to be replaced

hello ! were is the theft control module on my 94 camaro

Yes, there is a third bolt attaching the starter to the black support bracket on the back of the engine (use 12mm wrench)

driverside kickpannel......down by the left foot

Flooded in the river or flooded by gas? Any "check engine lights"? Full gas pedal depression is the normal way to clear gas flooding or first remove the spark plugs and blow out the excess gas.

check your links on the transmission cable.

There is a wire harness. The bulbs tend to go out.

yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.