take off your harmonic balancer the answer is behind
the crankshaft position sensor is located right behind the harmonic balancer mounted on the timing cover
How to install tps
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
how to remove crankshaft position sensor from 91 Buick Regal
The crankshaft position sensor on a Buick is located behind th Harmic balancer. It should have a wire plugged in to it.
How to take out crank shaft on century 2001 buick century
behind the power steering pump on the passenger side of the engine
The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
That would be around three feet and five inches, give or take.
Behind the crank pulley
The crankshaft position sensor is mounted on the front of the engine. It bolts on, and has one wiring plug.
Where is the MAF in 91 Buick century
Haynes repair manual available from www.amazon.com. Not hard. Locate sensor, unplug electrical connector, use socket of appropriate size, remove.
The Crankshaft Position Sensor is behind the crankshaft pulley (harmonic balancer). You will need a ½-inch drive breaker bar and appropriate socket.
show a diagram of a buick park avenue crankshaft sensor
The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.
The coolant temp sensor on a 97 Buick Century is on the side of the radiator. It is just below the radiator cap.
Behind the harmonic balancer.
front bottom of timing chain cover.
The sensor is on the front cover near the water pump area.
if it has a crankshaft sensor that's bad
Behind the crank pulley that your belt rides on!