I changed mine yesterday in a 1988 Park Ave. You have to first remove the passenger tire and plastic dirt schroud. The senser on my car is located below the water pump, and above the harmonic balancer on the left side. My research shows that your senser will be on the right side. Once you locate the senser, first disconnect the neg. terminal on the battery,next snap off the elec. connecter. A 3/8 bolt needs to be backed out, then you can remove the senser with your fingers. Reverse your steps to reinstall. Total time for the job was 1 hour 30 min. After doing the job once I'am comfortable that I could do the job in under 30 min.
The 2003 Saturn camshaft sensor can be found on the back of the cylinder head. The camshaft sensor should be labeled as such.
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
This. is the sensor found on the cylinder head in the vicinity of the camshaft which inform the ECM of its position, so the. spark.could be sent to the cylinder for ignition.of the cylinder.
The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
where is the camshaft exhaust positioning sensor on the in-line 5 cylinder motor, 2006 hummer h3
Where Is The Cam Sensor On A 2003 Hyundai Sonata 4 Cylinder
A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.
The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.
On a 4 cylinder it is on the end of the cylinder head. On a 6 cylinder it is part of the distributor.
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.