0
Purchase a re-manufactured half-shaft from an auto parts store. The half-shaft comes complete ready to install with a new CV joint. You will spend almost as much for the CV joint kit alone and spend more frustrating time trying to rebuild the old half-shaft.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Will a bad front axle on a 1992 subaru loyale make it shimmy when you accerate?
Yes, it will and generally it is the inboard cv joint.
Subaru 1988 clunking noise when turning in 4wd doesn't do it in 2 fwd?
check driveline, my universal joint went bad and did same, replace and was fine(1990 loyale)
How do you install front ball joint on a 99 Cadillac Escalade?
What kind of lower ball joint is used, on a cadillac escalade
Does Toyota make Subaru?
No. Subaru makes Subaru. The two companies did do a joint project. Toyota makes Lexus and scion.
How do you install CV joint on 2004 dodge ram 2500?
it has a solid front axle, therefore it has u joints, not cv joints found on independent front suspension(ifs) of GMs. CV joints are gonna be awful hard to install on a solid front end...
How do you replace a cv joint on a 2000 Subaru Outback?
how do you replace the drivers side drive shaft and cv joint?
How do you replace the ball joints on 1997 E-350 Van?
From: http://en.allexperts.com/q/Ford-780/Ball-Joint-Replacement.htm Ball Joint Replacement [Ford Van] Remove the brake disc. Remove the wheel speed sensor. For additional information, refer to Section 206-09. Remove and discard the cotter pin and nut. Disconnect the tie-rod end. Remove and discard the cotter pin and the nut. Remove the pinch bolt adjuster. CAUTION: To prevent damage to the ball joint seal and the ball joint socket, do not use a pickle fork-type remover to loosen the ball joints. Remove the front wheel spindle. Strike the lower end of the front axle to loosen the ball joint. Remove the front wheel spindle. To install, reverse the removal procedure. Check and, if necessary, align the front end. Remove the wheel spindle assembly. For additional information, refer to Wheel Spindle - E150-E450 in this section. Position the front wheel spindle in a vise, and remove the snap ring from the lower ball joint. CAUTION: To avoid damage to the components, do not use heat to aid ball joint removal. Using the special tool and suitable receiver cup, remove the lower ball joint from the front wheel spindle. Using the special tool and suitable receiver cup, remove the upper ball joint. Installation CAUTION: To avoid damage to components, do not use heat to aid installation. NOTE: Clean the wheel knuckle ball joint bores. NOTE: The lower ball joint must be installed first. Using the special tool with suitable receiver cups, install the lower ball joint. Using the special tool with suitable receiver cups, install the upper ball joint. Install the snap ring in the groove at the bottom of the ball joint. Install the front wheel spindle.
What is the purpose of a cv joint on a 2000 Subaru Outback?
Just a guess... but the constant velocity joint maintains appropriate speed on the wheel while in a turn.
How do you install lower ball joint for 97 dodge neon?
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
How do you remove and install ball joints in a Dodge Neon 1995?
Remove the tire and wheel. Remove the ball joint nut. Pound the ball joint out with a hammer or mallet. Reverse the process to install the new ball joint.
How do you install ball joint in Lincoln Continental?
year please.
How do you install butt-joint glazing for glass panels?
I need an answer
