Toyota 4Runner
Ford Bronco XLT
Ford Bronco II
Ford Explorer XLS

How do you install a rotor for a 1999 Toyota 4Runner?

616263

Top Answer
User Avatar
Wiki User
2005-10-18 03:37:46
2005-10-18 03:37:46

if your'e referring to a brake rotor, its as simple as removing the wheel, removing the 2 bolts that hold the caliper on, pulling the caliper out of the way and securing it, then sliding the old rotor off the hub. sometimes they rust in place. in which case you can beat it from behind with a big hammer til it comes off.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to replace brake fluid on a 1999 Toyota 4runner

User Avatar

how do I remove the climate control from a 1999 toyota 4runner

User Avatar

The 1999 Toyota 4runner OBD 2 port is under driver side dash near center console

User Avatar

The throttle position sensor on a 1999 Toyota 4Runner is located by the throttle body. It will be mounted near the throttle cable.

User Avatar

I would guess on the passenger side near the firewall. This is the location of my 2000 4runner.

User Avatar

Follow the transmission dipstick which is located just below your right windshield wipers in the engine bay. You should see a pan with a 10mm bolt ref. to auto trans 1999 toyota 4runner

User Avatar

Here is a web site that I saw that will help you on removing and replacing the starter on a 1999 Toyota 4Runner: http://www.4crawler.com/4x4/CheapTricks/Starter.shtml

User Avatar

5.5 quarts with oil/filter change.

User Avatar

They have 2 white colors for the 1999 4Runner and this code does not tell which one it is?

User Avatar

stick shift is loose and vibrates ,does it need new boots and how is it done

User Avatar

Second cylinder from the front (middle) on the driver side is #4.

User Avatar

buy a new bumper, remove the old one, and attach the new bumper

User Avatar

Check the door panel on driver side. It has a plate with the information specific for that year and model.

User Avatar

The cost to replace a 1999 Toyota 4Runner clutch runs between $145 and $300. This depends on if bought in a kit, part brand and any labor costs.

User Avatar

To change the rear shocks on a 1999 Toyota 4Runner the rear of the vehicle must be lifted with the wheels removed. Find the shock mounts and remove those nuts as well as the lower fork hardware. Each shock will slide out in whole assemblies.

User Avatar

front doors are 6 1/2 and rear doors I believe are 5 and 1/4 or 4"

User Avatar

Owner's manual. the jacks on all 4runner of this style are under the rear seats. just pull on the lock straps located at the folds of the seat and pull up and out and find the jack for your 4runner.

User Avatar

4 runner means four wheel drive. If the 4runner is only two wheel drive or the 4 wheel drive is not engaged, the rear wheels power the vehicle.

User Avatar

All you do is take out the screwon top and the lense assembley pulls out. It is tough to pull out but it will come.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.