all you have to do to get out the old one is there is a hole on bolth sides of the stero and if you get a hanger it will normally work and you just have to pull it out i thought i was going to break some thing but it was all good
I assume when asking this question that you would like to install an aftermarket stereo in place of the stock stereo in your Saturn. If that is the case, then hoepfully the following should get you started: 1. Purchase a wiring harness kit. This is available from Crutchfield or several other online warehouses. You will need to get a wiring harness that will adapt from the Saturn stock wiring to the new stereo. 2. Purchase a mounting kit. Your new stereo will be a slightly different size than the radio that was included with your vehicle. A mounting kit is required to mount the stereo cleanly in the vehicle and fasten it in place. 3. If need be, purchase an antenna adapter kit. For your vehicle this may or may not be necessary. 3. Conenct wiring harness kit to new stereo wiring. The harness will come with instructions or the wires will be labeled. Connect each wire from the harness to the appropriate one on the stereo. Solder these connections if possible, but twisting and taping can be done if need be. 4. Install mounting kit in dashboard of saturn. Follow the instructions that come with the mounting kit. They will vary for the different types and manufacturers of the kits. 5. Plug it all in. Plug in the wiring harness to the connector in the dashboard and the antenna adaptor ot the antenna then the stereo. 6. Test stereo. With the stereo still out of your dash, turn the key on and verify that the stereo works. 7. Push stereo into mounting kit and clean up. 8. Done!
picture on how to replace a water pump for mercury topaz
picture of the fan relay for 1993 mercury topaz
need diagram of rear brake lines for 1993 mercury topaz
yes
On a 1993 Mercury Topaz : Yes , both the 2.3 litre four cylinder engine and the 3.0 litre V6 engine use a timing CHAIN
Yes. Not an acessory outlet.
Inside the fuel tank.
Should be just one.
when the belt has no slack in it
Battery + cable goes to one of the large posts Starter cable goes to the other Large post Trigger wire goes to the small post (if there are 2 disregard 2nd)
Horn's should be in the fender wells in the engine compartment.
I do not know, but I am having the same problems with the removal of my 1994 tracer's stereo