Transmission Fluid
Fuel Filters
Chevy Silverado
Oldsmobile Toronado

How do you install a transmission filter in an 84 Oldsmobile Tornado front wheel drive 307 automatic?


Top Answer
User Avatar
Wiki User
2015-07-15 19:57:50
2015-07-15 19:57:50

drop the pan and take a look if the pan needs a new gasket (some had the rubber bpressed right in and of so then it's reusable) the filter kit come with a seal, a ring and the filter with a "snorkle" - remove the screws, gently pull down on the filter and make sure that the seal comes out with it - if not, fish it out of the hole but done gouge the sides - put the seal and ring on the snorkle and push the new one up until it seats itself - reinsert the screws and clean off the magnet on the plate - wipe clean and reinstall - dont over torque!!! -


Related Questions

User Avatar

This is a major mechanical project. Remove the clutch and manual transmission and the radiator. Install automatic transmission, new driveshaft, new radiator. You have just spent as much as a car is worth.

User Avatar

you can install an automatic transmission, but i wouldn't try one from a v6 unless your motor is a v6 as well

User Avatar

Standard or automatic transmission??? In most vehicle situations the switch unscrews out of the likage side of the transmission.

User Avatar

Put the van on the lift and drain the transmission fluid, next drop the transmission on a tranny jack and proceed to do a transmission overhaul. Reverse the proceedure to install.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.