get a longer bolt to start it . use this bolt until it is pulled up enuff to start the proper bolt
the harmonic balancer on the 350 is about 10 inches in diameter compared to a 305 it has about 8 inch diameter on the harmonic balancer
sounds like the rubber damper is worn on the harmonic balancer. if this is the case you will have to replace the harmonic balancer.
on the harmonic balancer there is a notch that represents 0 degrees and usually there are also stamped marks indicating degrees of advance and retard
There is a front pulley, a center bolt and washer AND a spacer behind the washer that has to come off before putting on the puller. I didnt know this and tried to pull balancer, this spacer is pressed in or it was after i tried to pull balancer off over it !
You Can Rotate The Engine By Turning The Harmonic Balancer, ( Crankshaft Pully Mounts On It ) By Using A Socket And Extension That Fits The Nut Holding The Balancer On It Will Be Rather Large Maybe 1 &1/2 Inch Or More. You Can (maybe hold the fan belt tight enough & turn the engine this way. Before I Did All This I Would Make Sure Its The Ring Gear & Not The Starter Drive. Good Luck
how do you install a aftermarket radio in 1986 caprice
How do you install an alternator belt on a 1986 GMC s15 pickup truck
the center bolt is for the harmonic balancer , aka , vibration damper or torsional damper . the torque specs. i have are 1985 and before 60 ft-lbs , 1986 to 1995 70 ft-lbs , 1996 and later 74 ft-lbs . can't find any specs. for the pulley bolts .
The House That Had Enough was created in 1986.
Valerie - 1986 Old Enough 1-1 was released on: USA: 1 March 1986
Enough Is Enough - album - was created on 1986-09-27.
Earn Enough for Us was created in 1986.