Want this question answered?
cutlass supremes are so baller
remove steering wheel with a puller, remove turn signal switch, remove tilt steering spring by pushing down and turning slightly counter clockwise, this should give you access to the torx screw . remove this screw and slide ignition lock cylinder out
Remove fuel tank for access
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
Take the gas tank down as the pump is inside the gas tank.
Replacing the brake pads on your 1982 Oldsmobile Cutlass is quite easy. Remove the brake pad Springs and caliper. The brake pads will come off. Reverse the process to install the new brake pads
sounds like pump is going, install new pump
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
go to the parts store and get a rear view mirror mounting kit and follow the instructions to a T.
Remove the 1998 Oldsmobile power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.