UNPLUG BATTERY FIRST!!!!!! Let vehicle set for about twenty minutes or so to make sure no residual power is left in system (capacitors). There should be two small sized 8mm(I think) screws that hold the bag on the the steering wheel from the back of the wheel. Bag should come out unplug the connector. You will probably have to replace the "clock spring" also. This is the piece that the airbag connector is connected too. The steering wheel will most likely have to come off to get this piece out. If you put in a another bag and clock spring and the airbag lights still light up then the airbag contoller unit has been blown also. Impossible to say for sure without replacing those two first. Hope this helps.
should be a catalyst on either driver or passenger side door
install 99 tail lights and there is no issue.. head over to www.ranger-forums.com for more answers
You have a 1999 Ford Ranger 3.0.
If you have a 1999-2000 Ford Ranger with a flex-fuel sensor it is located just under the driver side door on the inside of the frame and the fuel line coming from your fuel filter goes right to it. You unplug it then remove the fuel line on both sides of it and re-install the new one.
How do you remove the flywheel on a 1999 ford ranger
is there a recall on the timing belt on a 1999 ford ranger?
on my 95 i took the driver side tire and brake assembly off to get to it on my 95 i took the driver side tire and brake assembly off to get to it
yes it will i did it
how to replace a blend door actuator on a 1999 ford ranger
How do you install a rheostat in 1999 626 Mazda?
it's located towards the rear of the transmission body towards the driver side go in from the driver side and you'll see the pan under the trani and the plug is beside it not below it.
if the mustang wheels have 5 lug holes they will fit a ranger
( 160 horsepower ) for the 4.0 liter OHV , V6 engine in a 1999 Ford Ranger
The 1999 Ford Ranger ( SuperCab ) holds ( 19.5 U.S. gallons )
A Day in the Life of Ranger Smith - 1999 TV was released on: USA: 24 September 1999
how do you replace a turn signal flasher on a 1999 ford ranger pickup
The 4.0 L - V6 engine in a 1999 Ford Ranger has a compression ratio of ( 9.0 to 1 )
There is a heater control valve on the 1999 Ford Ranger. There is no thermal vacuum valve on this year of the vehicle.
On a 1999 Ford Ranger : The SuperCab body style is ( 73.8 litres / 19.5 U.S. gallons )
you dont they dont have grease zerks you have wait until they go out and then replace them with after market parts that have a place to install a zerk
tire size for 1998 2dr ford ranger is?
No. Different platform.