You need the rear panels out of a 92-95 civic si hatchback, they have rear mounts installed so that rear speakers can be fitted in, the CX, VX, and DX models did not come with them. Very had item to find, ive been looking for a few weeks with no luck.
Connect the wiring harness to the back of your new speakers. Secure the speakers into place with the retaining screws. Put the speaker cover on and secure it into place.
Attach the wiring harness to the back of the new speakers. Secure the speakers into place with the retaining screws. Put the speaker covers on.
Remove the speaker covers. Each speaker cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
You will need to remove the front speaker covers. The speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new speakers.
Reverse the process to install the newYou will need to remove the covers from your 2003 Chevy Cavalier rear speakers. The covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.
The Chevrolet equinox front speakers are held in place with two retaining screws. Remove the retaining screws and the wiring harness. The speakers will come out.
To hook up stereo speakers in a truck, attach the stereo wiring to the stereo and run it to the speakers. Clip the stereo speakers into the wires and place them in the panel spaces in the truck.
Use a screwdriver to pry open the speakers casing. Then, disconnect the speakers and slide them out. Connect the new ones, slide them back in and screw the casing back on. It's that simple. You will need a flat tip screwdriver as well as a cross point screwdriver for this job. Use it to pry your speaker covers off and then unscrew the screws holding in the speakers. Disconnect the speakers and plug in the new ones. Slide the speakers back into place and put the covers back on.
either the fuses are bad or there is a short in the wiring from the deck to the speakers. or one of the fuses have popped out of place
It is moderately easy to install by yourself. It'll make it easier if you understand the surround sound speakers and determine the place to install the Bose beforehand.
Remove the door speaker cover. The cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.
Make sure that you have the correct wiring that you need and then follow the wiring diagram that came with your lights. You may also need to decide on the best place to place your motion sensor if you have that type of lighting.