put the car up on jack stands, grab the front wheel and yank it up and down and side to side, it shouldn't have any play in it at all. if it does it can be one of a few causes 1>cracked/bad bushings 2>worn tie rod 3>bad wheel bearing 4>loose a-frame 5>worn ball joints 6>worn strut/spring/shock when i say yank i mean yank, put some a$$ in to it, just pay attention to what gives when you put some force on it, and don't put the jack stands under the a-frame that just going to load the suspension, put the jack stands under the k-member, don't forget to set the e-brake, if its a standard put it in gear with engine off of course decipha@murdacapital.com
1998 2wd What year? 2WD or 4WD? 2WD 1996
You need to remove the spindle and press out the ball joints & press in new ones
how do i change a lower ball joint on a 1992 ranger 2wd
Depends on whether you have coil springs or torsion bars.
What is the timing for a 1998 ford ranger 2.5l
My Ford Ranger is a 1998 4.0 ltr V6.
how to replace u-joints on 1995 ford ranger 2wd
It depends on the year, and whether it's 2WD or 4WD. I suggest entering your question again with the year. People have posted answers for specific year models. All Ford Rangers from 1993 to 1997 have "I-beam" front suspensions as opposed to the upper and lower control arms that most vehicles have. There is a detailed answer for replacing the upper and lower ball joints for '93 through '97 Ford Ranger ball joints at the question: "How do you change ball joints on 199X Ford Rangers?"
I believe on the 4 x 4 , with the torsion bar suspension , the upper ball joints are part of the control arm and the lower ball joints can be replaced separately or with a new control arm The 2 wheel drive , with the coil spring front suspension , the upper and lower ball joints can be replaced separately
There is not a good and clear indication on how many ball joints are on a 2000 Ford Mustang. After searching around, there are conclusions that there are at least two ball joints on the Mustang.
No, the cab was lengthened in the 1998 model year.
what is the axle gear ratio for a 1998 ford ranger 4x4 4.0l?