You will get proper combustion in all pistons. Also a bad head gasket could blow steam out the tail pipe even after the car is warmed up. Another symptom of a blown head gasket is bubbles forming in the radiator tank. The head gasket provides the seal between the cylinder head and the block. It prevents water and oil from getting into the cylinders, and into each others channels. If the engine is smoking badly, or steam is coming out the tail pipe in large amounts, the head gasket may be shot. If you have white foam in the oil, that is evidence that water is getting into the oil system, and, if there is an oily sludge showing up in the coolant, than oil is getting into the water system.
A compression test can reveal if a head gasket is leaking, which can be done quickly by a mechanic. A car may run with a blown head gasket, but usually not very well.
I don't know which one was at fault but I replaced the head, the head gasket, and the intake manifold gasket.
what are you asking here? PLease be more specific ...like - how do I know if my head gasket is blown, or what do I do about a blown head gasket ......
You will not know until your remove the head. You have to remove the head in order to replace the gasket and once you have the head removed have it magna fluxed at a machine shop. That will reveal any cracks.
you will have antifreeze in your oil!
You may not see anything on the gasket. Usually a head gasket "blows" because of overheating that causes the head to warp. A gasket can be bad but there should be a visable break very often in the ring around the cylinder.
You will need a new head gasket if you see engine coolant in the oil. I don't know about the thermostat.
perform a pressure test on the cylinders. if they don't hold pressure it's a blown head gasket
They don't work and are only an emergency repair. If you have a blown head gasket the only way to repair it is to replace it.
I
You will have to remove the head, inspect the gasket for breaks, check the head for flatness, and have a machine shop test the head.You will have to remove the head, inspect the gasket for breaks, check the head for flatness, and have a machine shop test the head.
If you remove the head then of course you replace the head gasket.Where can you get sodium silicate to fix a blown head gasket?Know that adding sodium silicate to an engine is only a temporary fix for a blown head gasket and will not permantly fix the problem. The only permanent fix is to replace the head gasket. I would never add any head gasket fix material to any engine.
my head gasket was blown and it had water in the oil which made the oil look a milky color