0
How do you know if the fuel shut off switch is good it seems like it is already pushed in HELP?
Wiki User
∙ 18y ago
Use a test light. Attach the alligator clip to a good ground and pierce the power supply wire going into the switch. Turn the key on and there should be power for 2 seconds. Then pierce the wire coming out of the switch to the pump and cycle the key off, then back on. There should be the same 2 second on signal. If you have power going into the switch, and no power coming out, it's bad.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace the stop light switch on a 97 Avalon you already bought the part you need help getting the one that in there out?
The 1997 Toyota Avalon stop light switch simply plugs in and out. Take hold of the stop light switch and pull outward. Plug the new stop light switch in.
How do you connect a switch to a light then another light to a switch and have the switch work only the light on its end?
go to the Help option in Matlab. It will not help at all.
Have a 91 Chevrolet Z71 4x4 All lights work except brake lights Seems there is no power going to brake light switch Help?
have power to fuse box but not brake lgt switch new bulbs all wiring ckd brklgt switch replaced. this should be up with my question new here oops
How did mountain men help to open up the west?
They pushed away from North
How did mountain men help open up the west?
They pushed away from North
How do you change ignition switch in 95 S10?
help help
Where is the fuel pump shut-off switch on a 1989 Ford Probe GT?
If you haven't already had this question answered then maybe I can help. I believe it is located underneath the driverside dash where you will locate the fuse panel. The fuel pump shut off switch is the first black square fuse, there should be three of them lined up verticly. That should help you out.
How do you change a head light switch on a 1970 Chevy pickup?
You have to reach up under the dash with your hand and push the spring loaded button located on the switch. This will release the headlight knob and let you pull it all the way out. Now you can unscrew the retaining nut outside the dash that holds the switch in place. Now you can lower the switch down to where you can disconnect the electrical plug. If you already have the new switch you can notice the location of the spring loaded button to help you find it on the original switch.
The key and steering wheel on a 1992 Toyota 4Runner are locked uo can you help?
This happens to my 98 4runner every so often. Today it was really bad - couldn't move the steering wheel or move the key. I put it in neutral and literally got out and pushed it. That did the trick, steering wheel unlocked. Moving the tires seems to help...
How do you change a dimmer switch?
help mower!
You got the got the coil blown out and you still can't get air to blow out of the vents in your 92 bonnevilleHeatair;the fan is working but air barely blow out even with switch on high please help?
It seems that the blower motor has gone bad.
Already replaced blower motor and resistor heater is still not blowing air please help?
Assuming there is no blower speeds at all, check the blower speed switch and the electrical plug into the back of it. You may find the plug melted. The switch and plug (pig tail) are available from most parts stores.
