answersLogoWhite

0


Best Answer

Assuming there is no blower speeds at all, check the blower speed switch and the electrical plug into the back of it. You may find the plug melted. The switch and plug (pig tail) are available from most parts stores.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Already replaced blower motor and resistor heater is still not blowing air please help?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2003 Toyota Echo Ac stoped blowing air where is blower located?

If the AC stopped blowing air on your 2003 Toyota Echo, the blower fuse could be to blame. If the fuse is fine, it might be the blower resistor that needs to be replaced.


Why wont your blower run in your 96 gmc already replaced the relay?

Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.


Fiesta heater not blowing?

Blown fuse, defective blower motor, or defective blower motor resistor pack.


Where do you look next Already replaced resistor pack for blower and still don't have 1 through 4 speeds?

Check the switch and connectors.


I have replaced the blower motor resistor and It blows on 1 and then it stops blowing completely what is the problem here?

Have you checked to see if your 12V dc relay under the hook is working properly?


How to replace blower resistor in 2002 olds intrigue?

A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.


Fan blower switch for 2002 Chevy impala ac and heater only works in high position already replaced unit with new one?

Defective blower motor resistor pack.


How do you diagnose a heater blower motor problem on a 2001 grand prix?

If the blower only works on high the blower resistor is most likely the problem and should be replaced. On rare occasions if the car has blown the resistor more than once the blower motor shouuld be replaced.


The blowers on your ford focus do not work on low speed?

heater blower resistor has to be replaced. you have to remove glove boxthe resistor is to the right of the heater blower moter


Why does the blower fan only work on high in a 2006 Chrysler Sebring?

blower motor resistor needs to be replaced


Heater blower will not work on 1992 Mazda 626. already replaced resistor block.?

You probably need a blower motor. Check the Hot electrical feed to the motor. If you have replaced the resistor block you know where the motor is located (just to the right) It is easy to replace and can be purchased everywhere, including a junk yard. Remember some Resistor Blocks fail because the motor is old and drawing to many amps.


Why did your heater in your van stop blowing?

Blown fuse, defective Blower Motor Resistor Pack, Defective Blower Motor, or Defective Blower Motor speed control switch.